User manual

3. Tilt motor head back.
4. Slip beater onto beater shaft and
press upward as far as possible.
5. Turn beater to right, hooking
beater over pin of shaft.
6. Plug into a grounded 3 prong
outlet.
To Remove Flat Beater, Wire
Whip Or Dough Hook
1. Turn speed control to OFF.
2. Unplug stand
mixer.
3. Tilt motor
head back.
4. Press beater
upward as far as possible.
5. Pull beater from beater shaft.
To Lock Motor Head
1. Make sure motor head is
completely down.
2. Place locking lever in LOCK
position.
3. Before mixing, test lock by
attempting to raise head.
To Unlock Motor Head
1. Place lever in UNLOCK position.
NOTE: Motor head should always
be kept in LOCK position when
using stand mixer.
To Operate Speed Control
Plug into a grounded 3 prong
outlet. Speed control lever should
always be set on lowest speed for
starting, then gradually moved to
desired higher speed to avoid
splashing ingredients out of bowl.
See the “Speed Control Guide”
section.
To Attach Bowl
1. Turn speed control to OFF.
2. Unplug stand mixer.
3. Tilt motor head back.
4. Place bowl on bowl clamping
plate.
5. Turn bowl gently in clockwise
direction.
6. Plug into a grounded 3 prong
outlet.
To Remove Bowl
1. Turn speed control to OFF.
2. Unplug stand mixer.
3. Tilt motor head back.
4. Turn bowl in counterclockwise
direction.
To Attach Flat Beater, Wire Whip,
Or Dough Hook
1. Turn speed control to OFF.
2. Unplug stand mixer.
11
Assembling Your Tilt-Head Mixer
ON
OFF
Lock Unlock
Solid State Speed Control
Off Stir 2 4 6 8 10
PIN
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.