Installation guide

INSTALLATIONINSTRUCTIONS

Depending on your model, the mounting plate may be in the foam

packaging, or it may be attached to the back of the microwave

oven.

NOTE: To avoid possible damage to the work surface, cover the

work surface.

1. Remove any remaining contents from the microwave oven

cavity.

2. If the mounting plate is attached to the back of the microwave

oven, remove it and set it aside.

3. Tape the microwave oven door closed so that door does not

swing open while the microwave oven is being handled.

NOTE: To avoid damage to the microwave oven, do not grip or

use the door or door handle while the microwave oven is being

handled.

3. Remove 2 screws attaching blower motor to back of

microwave oven.

A. Screws (inrecessed holes)

Lift blower motor out of microwave oven.

The microwave oven is set for recirculation installation. For wall or

roof venting, changes must be made to the venting system.

NOTE: Skip this section if you are using recirculation installation.

Keep the damper assembly in case the venting method is

changed, or the microwave oven is reinstalled in another location

where wall or roof venting may be used.

Wall Venting Installation Only

1. Remove screws attaching damper plate to top of microwave

oven exterior. Slide damper plate toward the front of the

microwave oven and lift up.

A. Blower motor

Rotate blower motor 180° so that exhaust ports face the back

of microwave oven, and lower blower motor back into the

microwave oven.

A. Exhaust port

"-....

A. Screws

B. Damper plate

2. Keep damper plate and screws together and set aside.