Quick Reference Guide Cooking gestures are invisible ingredients. They turn inspiration into emotions and emotions into a masterpiece. It’s all about artisanality, that’s why we take it so seriously.
Index EN ���������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������������page 3
KitchenAid Gas Hob EN CY Instructions for Use Cooking gestures are invisible ingredients. They turn inspiration into emotions and emotions into a masterpiece. It’s all about artisanality, that’s why we take it so seriously.
Safety Instructions Important To Be Read And Observed Download the complete instruction manual on http://d ocs.kitchenaid.eu or call the phone number shown on the warranty booklet. WARNING : Danger of fire : Do not store items on the cooking surfaces. CAUTION : The cooking process has to be supervised. A short cooking process has to be supervised continuously. WARNING : Unattended cooking on a hob with fat or oil can be dangerous – risk of fire.
PERMITTED USE problems, contact the dealer or your nearest After-sales Service. Once installed, packaging waste (plastic, Styrofoam parts etc.) must be stored out of reach of children - risk of suffocation. The appliance must be disconnected from the power supply before any installation operation - risk of electrical shock. During installation, make sure the appliance does not damage the power cable - risk of fire or electrical shock. Only activate the appliance when the installation has been completed.
advisable to keep only the cylinder being used in the room, positioned so that it is not subject to heat produced by external sources (ovens, fireplaces, stoves, etc. ) which could raise the temperature of the cylinder above 50°C. Carry out all cabinet cutting works before fitting the appliance in the furniture and remove all wood chips and sawdust. If the appliance is Not installed above an oven, a separator panel (not included) must be installed in the compartment under the appliance.
ADAPTING TO DIFFERENT TYPES OF GAS DISPOSAL OF PACKAGING MATERIALS The packaging material is 100% recyclable and is marked with the recycle symbol . The various parts of the packaging must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal.
INJECTORS TABLE Type of gas used Type of burner Injector marking Rated thermal flow rate NATURAL GAS (Methane) G20 Rapid Semi-rapid Auxiliary 2 Ring 125 A 97 A 78 C 149 H3 LIQUEFIED PETROLEUM GAS (Butane) G30 Rapid Semi-rapid Auxiliary 2 Ring LIQUEFIED PETROLEUM GAS (Propane) G31 Rapid Semi-rapid Auxiliary 2 Ring CATEGORY II2H3+ Rated consumption Reduced heat capacity kW min. rat. max.
Installation TECHNICAL INFORMATION FOR THE INSTALLER • Use protective gloves for handling, preparing and installing the product. • This product can be embedded in a worktop 20 ÷ 60 mm thick. • If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob.
Product Description 1. Removable panstand grids 2. Rapid burner 1 2 3 1 Shaded circle 3. Semi-rapid burner Large flame 4. 2 Ring burner Small flame 5. Semi-rapid burner 1 5 Symbols 6. Auxiliary burner 4 7. Rapid burner control knob 6 8. Semi-rapid burner control knob 9. 2 Ring burner control knob 10. Semi-rapid burner control knob 8 7 9 10 11 11. Auxiliary burner control knob Daily use HOW TO USE THE HOB • Avoid accidentally knocking the hob with pans,racks or other kitchen utensil.
ADJUSTING MINIMUM GAS SETTING OF TAPS To ensure that the minimum setting is correctly adjusted, remove the knob and proceed as follows: • tighten screw to reduce the flame height (-); • loosen screw to increase the flame height (+).
Maintenance and cleaning Disconnect the appliance from the power supply. CLEANING THE HOB SURFACE • All the enamelled and glass parts should be cleaned with warm water and neutral solution. • Stainless steel surfaces may be stained by calcareous water or aggressive detergents if left in contact for too long. Any food spills (water, sauce, coffee, etc.) should be wiped away before they dry. • Clean with warm water and neutral detergent, and then dry with a soft cloth or chamois.
After-Sales Service In order to receive a more complete assistance, please register your product on www.kitchenaid.eu/register. BEFORE CALLING THE AFTER-SALES SERVICE: 1. See if you can solve the problem by yourself with the help of the suggestions given in the TROUBLESHOOTING. 2. Switch the appliance off and back on again to see if the • the service number (number after the word Service on fault persists. the rating plate).
Please refer to our website www.kitchenaid.eu for complete instructions for use. In addition, you will find a lot more useful information about your products, such as inspiring recipes created and tested by our brand ambassadors or the nearest KitchenAid cookery school.
WHIRLPOOL EMEA S.P.A. via Carlo Pisacane n.
EN Printed in Italy 400011364468
