Installation guide

,,J

NOTE: If the minimum cabinet opening height is less than 34"

(86.4 cm), the rear wheels can be removed for additional

clearance. This will allow the dishwasher and perforated section

of the insulation blanket to fit into a 331/2'' (85.1 cm) high cabinet

opening, but the dishwasher will be more difficult to move.

Measurements are approximate. Wheels and legs are preset at

the factory for 341/2'' (87.6 cm).

Cut insulation blanket along perforation for cabinet opening height

of 331/2'' (85.1 cm). For other cabinet opening heights, do not cut.

Adjust wheels and legs

Turn both leveler legs to the same height. Put wheels in the

required position determined from "Dishwasher Height

Adjustment Chart."

Built-up floors: If the kitchen floor is higher than the cabinet

opening's floor - for example, the kitchen floor tile does not

extend into the cabinet opening - add shims as needed in the area

shown to bring the dishwasher up to 34" (86.4 cm) below the

countertop.

NOTE: Shims must be securely attached to floor to avoid

movement when the dishwasher is in use.

}sc_ ©uO e de

Mounting stud

Handle

Setscrew

(in bottom

of handle)

Hex key

IMPORTANT: Do not scratch the front panel during this

procedure.

Remove the door handle and hardware bag containing the

setscrews and hex key from the cardboard box. Setscrews are

already installed in the handle. Place handle on mounting studs

with the setscrews facing down. Push the door handle tightly

against the door. Insert the short end of the hex key into the

setscrews. Tighten the setscrews 1/4turn past snug.

Retain hex key with Installation Instructions.