® HEAVY DUTY GEBRUIKSAANWIJZING MIXERS MIXER INSTRUCTIONS ROBOTS DE CUISINE : MODE D’EMPLOI GEBRAUCHSANLEITUNG - KÜCHENMASCHINE ISTRUZIONI D’USO INSTRUCCIONES PARA BATIDORA Kitchen Aid St. Joseph , Michiga n, USA 0 0 8 10 4 6 12 id nAan, USA hig itcephhe , Mic KJos St.
Table of Contents English Important Safety Instructions....................................................................................3 About Your Mixer Model 5K45SS Mixer Features .........................................................................4, 5 Model 5K5SS/5KPM5 Mixer Features..............................................................6, 7 Using your KitchenAid® Attachments...................................................................8 Beater To Bowl Clearance....................
Important Safety Instructions When reading the Instructions Manual… Pay special attention to sections marked by the following words: ! CAUTION ! WARNING These help you avoid accidents that could lead to injury for someone using the product incorrectly. These help you avoid damage to the product and/or other property. “NOTE:” or “IMPORTANT” These sections give you helpful tips on using the product. 11.
5K45SS Mixer Features Attachment Hub English Motor Head Speed Control Lever 0 12 8 4 6 Attachment Knob Motor Head Locking Lever (not shown) Beater Shaft 10 id nA n, USA cheichiga KJoitseph, M St. Flat Beater R-4 Wire Whip 4.5 Qt (4.
0 12 8 10 4 6 d , USA enAi igan tch Mich ph, KiJose St. ON TO LOCK MOTOR HEAD IN RAISED POSITION • Push locking lever up into UNLOCK position and hold. • Tilt motor head back. • Move locking lever into LOCK position. TO ATTACH BOWL • Be sure speed control is OFF. • Tilt motor head back. • Place bowl on bowl-clamping plate. • Turn bowl gently in clockwise direction (see picture above). • Sit pouring shield on bowl.
5K5SS/5KPM5 Mixer Features Motor Head Attachment Hub English Attachment Knob Speed Control Lever Kitchen Aid h, Michi St. Josep gan, USA 0 12 4 6 8 10 Heavy Du ty Bowl Lift Handle (not shown) Spring Latch and Bowl Pin (not shown) Locating Pins Beater Shaft Bowl Support Flat Beater Wire Whip Dough Hook 5 Qt (4.
TO ATTACH FLAT BEATER, WIRE WHIP, OR DOUGH HOOK • Turn speed control to OFF and unplug. • Lower bowl by rotating bowl lift handle downward. • Slip flat beater on beater shaft and press upward as far as possible. • Turn beater to right, hooking beater over the pin on shaft. TO REMOVE BOWL • Place bowl lift handle in down position. • Grasp bowl handle and lift straight up and off locating pins. Heavy Dut TO REMOVE FLAT BEATER, WIRE WHIP, OR DOUGH HOOK • Turn speed control to OFF and unplug.
Using Your KitchenAid® Attachments Dough Hook for mixing and kneading yeast doughs, such as: breads coffee cakes rolls buns Beater To Bowl Clearance Your mixer is adjusted at the factory so that the flat beater just clears the bottom of the bowl. If, for any reason, the flat beater strikes the bottom of the bowl, or is too far away from the bowl, clearance can be corrected as follows: Model 5K5SS/5KSM5/5KPM5 • Place bowl lift handle in B down position.
Planetary Mixing Action Your KitchenAid® Mixer will mix faster and more thoroughly than most other electric mixers. Therefore, the mixing time in most recipes must be adjusted to avoid overbeating. English During operation, the flat beater moves around the stationary bowl, at the same time turning in the opposite direction on its own axis. The diagram shows the complete coverage of the bowl made by the path of the beater. Mixer Use The mixer may warm up during use.
Mixing Tips English Converting Your Recipe to the Mixer The mixing instructions found in this book can be used to convert your favorite recipes for use with your KitchenAid® Mixer. To help determine a mixing procedure, your own observations and experience will be needed. Watch the batter or dough and mix only until it has the desired appearance described in your recipe, such as “smooth and creamy.” Use the “Speed Control Guide” to help determine proper mixing speeds.
n, USA 0 12 46 8 10 5. When dough clings to hook, knead on Speed 2 for 2 minutes or until dough is smooth and elastic. NOTE: These instructions illustrate bread making with the Rapid Mix method. When using the conventional method, dissolve yeast in warm water in warmed bowl. Add remaining liquids and dry ingredients – except last 1 to 2 cups (250 mL to 500 mL) flour. Turn to Speed 2 for about 1 minute, or until ingredients are thoroughly mixed. Proceed with steps 4 through 6.
When You Need Service English Please read the following before calling your service center. 1. The mixer may warm up during use. Under heavy loads with extended mixing time periods, you may not be able to comfortably touch the top of the unit. This is normal. 2. The mixer may emit a pungent odor, especially when new. This is common with electric motors. 3. If flat beater strikes bowl, stop the mixer. See “Beater to Bowl Clearance.
