Owner manual
11
DMX Operation
DMX Addressing
Prior to hanging any instruments,
set the DMX address of each xture.
Push the tabs above or below the
number window to set the address.
(Valid addresses range from 001 to 512.)
The light above the address block will
illuminate if a DMX signal is present.
Tip: Power is not required to set
DMX addresses. Therefore, DMX
addresses can be set for each xture
prior to hanging.
Image 87 operates on 9 DMX addresses:
Lamps = 1-8, HO/Std = 9
Image 47 operates on 5 DMX addresses:
Lamps = 1-4, HO/Std = 5
The 9th address (5th address for Image 47) controls the HO/Std setting.
Dimmer level from 0%~50% operates all the lamps at HO mode. Dimmer
level from 50%~100% operates the lamps in the Std mode and the overall
light output of the xture drops by ½ f-stop.
For the sake of simplication, it is advisable to select address sequences
such as 10, 20, 30, 40 and so on.
IMPORTANT!
The dimmer board/light console should have its channel set to LINEAR light
output response. (LINEAR response is the default setting on most dimmer
boards.)