Installation Guide

ASSEMBLY INSTRUCTIONS
6
FLUSHMOUNT ASSEMBLY ONLY
FLUSHMOUNT ASSEMBLY ONLY
3. Temporally hang motor assembly (F) on the hanging
bracket (A) to allow the electrical connections to be
made.
Raise motor assembly (F) and place one of the
round holes on the canopy (C) onto the tab from the
hanging bracket (A). This will allow for hands-free
wiring.
Note: Proceed to step 8 after this step.
2. Before starting this step you must remove the canopy hole cover from the canopy (C). Remove
three screws from the top of the motor assembly (F) and save them for later use. Lower canopy
(C) onto the motor assembly (F) making sure the slots on the canopy (C) line up with the
remaining screws on the motor assembly (F). Attach canopy (C) to the motor assembly (F) with
the screws you just removed.
2a2a
2b
F
C
CC
Canopy
Hole
Cover
Screw
3
F
A