Instruction Manual

Instruction Manual
14
KGS Corporation
1.8 Preparation for PC before connect BL-1000 LINK with it
Two kinds pieces of software are attached with BL-1000 LINK.
(A) USB Driver for BL-1000 LINK – This is the requisite software to connect BL-
1000 LINK with PC through USB cable.
Be sure to install this USB Driver into PC before connect BL-1000 LINK with PC.
(B) Braille Labeler Utility – This is an Utility software to make easily braille
label by use of BL-1000 LINK.
Those software’s are correspondent to the following version of OS.
Windows ® 7/8/8.1/10 (64/32)
Please use the PC, that OS as shown above are working inside.
Attention
Depending on your PC environment, you may need administrator privileges to
install the software. In that case, please contact your system administrator.
When you set the attached software CD (Braille Labeler BL-1000 LINK Support
Disk) in CD drive of your PC, the following page index is opened.
If it doesn’t open automatically, please open the CD drive directly and double-
click the “index.htm” file.