User Manual

5.3 Module/Unit Connections
KV-300
KV-10/80
1
5
Chapter 5 KV-300 Hardware
1-189
5.3.9 Connector Assembly Instructions
Connector assembly
OP-21734 crimping tool
■ Part names
■ Applicable cables
Contact removal
To remove a contact from the connector, align the contact with the arrow mark on
the crimping tool. Pull the cable while pushing the contact against the tool. The
contact will remain in the contact holder.
Crimping contact to cable
1. Separate a contact from the contact carrier.
1
18
2
19
3
20
4
21
5
22
6
23
7
24
8
25
9
26
10
27
11
28
12
29
13
30
14
31
15
32
16
33
17
34
1
11
2
12
3
13
4
14
5
15
6
16
7
17
8
18
9
19
10
20
(The above figure represents the pin assignment of the
connector viewed from the left.)
Handle
Pressure punch
Crimping unit
Contact removal pin
Cover
Contact holder
Guide
Specifications
Cable size Sheath outer diameter
AWG 22 to 24 (stranded) Cross-section: 0.2–0.3 mm
2
1.1 –1.5 mm dia.
Pull the cable while pushing the contact against the crimping tool.
Cable
Contact removal pin
Cut in this direction.
Cut here.
KVHKA Chap 05.p65 08.3.11, 11:14 AM189