User Manual

3-3 Adjusting the Sensitivity

Basic Operation

3-14

- Digital Laser Sensor LV-N10 Series User's Manual -

This method automatically sets sensitivity using a moving workpiece.

Sensitivity can be easily set by passing a workpiece without shutting down operating

equipment.

While the workpiece passes through,

press and hold the [SET] button until

"SEt" flashes.

After the workpiece has completely

passed through, release the [SET] but-

ton.

Calibration is complete after the setting

value flashes momentarily, and then

stops (lights up).

• If detection is not stable after the setting operation, for example due to

vibration, press the button to adjust the setting value.

• When performing two-point calibration on channel 2 of the 2-output type,

set the channel switch to "2".

Full Auto Calibration

Reference

Setting

value

MAX

MIN

Time

Received

ht intensity

The setting value is determined

as the middle value between the

maximum and minimum light

intensity received values

obtained while holding down the

[SET] button.