User Manual

INSTALLING THE TRANSCEIVER

For passenger safety, install the transceiver securely, using the supplied mounting bracket, so the

transceiver will not break loose in the event of a collision.

1 Mark the position of the holes in the dash by using the mounting bracket as a

template. Drill the holes, then attach the mounting bracket using the supplied

5 x 16 mm screws.

• Be sure to mount the transceiver in a location where the controls are within easy

reach of the user, and where there is sufficient space at the rear of the transceiver

for cable connections and ventilation.

2 Connect the antenna and the supplied power cable to the transceiver.

3 Slide the transceiver into the mounting bracket and secure it using the

supplied hex-headed screws.

4 Mount the microphone hanger, using the supplied 4 x 16 mm screws, in a

location where it will be within easy reach of the user.

• The microphone and microphone cable should be mounted in a place where they

will not interfere with the safe operation of the vehicle.

5 Connect the microphone plug to the microphone jack on the front panel of the

transceiver, then place the microphone on the hanger.

When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same value.

Never replace a fuse with a fuse that has a higher value.

Hex-headed

screw

Microphone

hanger

DC power cable

Mounting bracket

5 x 16 mm

self-tapping screw

4 x 16 mm

self-tapping

screw

Spring

washer

Antenna

connector

Power input

connector

Fuse (15A)

BlackRed

Flat washer