User's Manual

30 English
Installation/connection
Part list:
A Faceplate ...................................................................(×1)
B Escutcheon ..............................................................(×1)
C Mounting sleeve ...................................................(×1)
D Wiring harness .......................................................(×1)
E Removal tool .......................................................... (×2)
F DAB antenna film *
1
............................................(×1)
G DAB antenna amplifier *
1
.................................(×1)
H Cord clamper *
1
.................................................... (×3)
I Cleaner *
1
................................................................... (×1)
• *
1
KDC-DAB41U only
Basic procedure
1 Remove the key from the ignition switch,
then disconnect the · terminal of the
car battery.
2 Install the DAB antenna.
\ <Installation the DAB antenna
(KDC-DAB41U only)> (page 34)
3 Make proper input and output wire
connections.
\ <Wiring connection> (page 32)
4 Install the unit to your car.
\ <Installing the unit> (page 33)
5 Reconnect the · terminal of the car
battery.
6 Reset the unit. (page 3)
Warning
■
The unit can only be installed in a car with a
12 V DC power supply, negative ground.
■
If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit,
that in turn may start a fire. Always connect
those wires to the power source running
through the fuse box.
■
Disconnect the battery’s negative terminal
and make all electrical connections before
installing the unit.
■
Insulate unconnected wires with vinyl tape
or other similar material. To prevent a short
circuit, do not remove the caps on the ends
of the unconnected wires or the terminals.
■
Be sure to ground this unit to the car’s
chassis again after installation.
■
If the power is not turned ON (“PROTECT”
is displayed), the speaker wire may have a
short-circuit or touched the chassis of the
vehicle and the protection function may
have been activated. Therefore, the speaker
wire should be checked.
Caution
■
If your car’s ignition does not have an ACC
position, connect the ignition wires to a
power source that can be turned on and
off with the ignition key. If you connect
the ignition wire to a power source with
a constant voltage supply, as with battery
wires, the battery may die.
■
Install this unit in the console of your
vehicle. Make sure the faceplate will not hit
the lid of the console (if any) when closing
and opening.
■
After the unit is installed, check whether the
brake lamps, blinkers, wipers, etc. on the car
are working properly.
■
Mount the unit so that the mounting angle
is 30° or less.
■
If the fuse blows, first make sure the wires
are not touching to cause a short circuit,
then replace the old fuse with one that has
the same rating.
■
Connect the speaker wires correctly to the
terminals to which they correspond. The
unit may be damaged or fail to work if you
share the · wires or ground them to any
metal part in the car.
B64-4833-00_01_E.indb 30B64-4833-00_01_E.indb 30 11/03/07 11:0911/03/07 11:09