Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Clock Set (Menu Item)
- Demo Mode (Menu Item)
- Table of Contents
- Removing / Attaching Faceplate
- Parts & Controls
- Operation
- Bluetooth Setup
- Registering a Bluetooth Device
- Registering a Special Bluetooth Device
- Registering PIN Code
- Downloading the Phone Book
- Selecting the Bluetooth Device to Connect
- Deleting a Registered Bluetooth Device
- Displaying Firmware Version
- Adding a Voice Dialing Command
- Setting a Voice Command for Category
- SMS
- Downloading the SMS
- Menu System
- Installation
- Additional Information
- Troubleshooting
- Messages
- Specs
- Scan of Software CD-ROM
- Note for Music Editor Software
- Note on Demonstration Mode
- Warranty
ACAUTION
Use
of
controls or adjustments or performance
of
procedures other than those specified herein may
result
in
hazardous radiation exposure.
In
compliance
with
Federal Regulations, following
are
reproductions
of
labels on, or inside the product
relating
to
laser product safety.
Kenwood Corporation
2967-3,
ISHIKAWA-MACHI,
HACHIOJI-SHI
TOKYO,
JAPAN
KENWOOD
CORP.
CERTIFIES
THIS
EQUIPMENT
CONFORMS
TO
DHHS
REGULATIONS
NO.21
CFR
1040.
10,
CHAPTER
1,
SUBCHAPTER
J.
Location: Bottom
Panel
FCC
WARNING
This equipment may generate or
use
radio
frequency energy. Changes or modifications
to
this
equipment may cause harmful interference unless
the modifications
are
expressly approved
in
the
instruction manual. The user could lose the authority
to operate this
equipment
if
an
unauthorized change
or modification
is
made.
FCC
NOTE
This equipment
has
been tested and found to
comply
with
the limits for a
Class
B digital device,
pursuant to
Part
15
of
the
FCC
Rules.
These limits
are.
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment may cause harmful interference
to
radio
communications,
if
it
is
not
installed and used
in
accordance
with
the instructions. However, there
is
no guarantee that interference will
not
occur
in
a
particular installation. If this
equipment
does cause
harmful interference to radio or television reception,
which
can
be determined by turning the equipment
off
and on, the user
is
encouraged to try
to
correct
the interference by one or more
of
the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into
an
outlet on a
circuit different from that
to
which the receiver
is
connected.
• Consult the dealer or
an
experienced
radiofN
technician for help.
Contains Transmitter
Module
FCC
10
•
RKXCK5050
Contains Transmitter Module
IC
: 5119A-CK5050
IC
(Industry Canada) Notice
Operation
is
subject
to
the
following
two
conditions:
(1)
This device may
not
cause interference, and
(2)
this device must accept any interference, including
interference that may cause undesired operation
of
the device.
The term
"IC:
" before
the
certification/registration
number only signifies that the Industry Canada
technical specification were met.
The
"AAC"
logo
is
trademark
of
Dolby Laboratories.
The Bluetooth word mark and logos
are
owned
by
the Bluetooth
SIG,
Inc. and any
use
of
such marks
by Kenwood Corporation
is
under license. Other
trademarks and trade names
are
those
of
their
respective owners.
iTunes
is
a trademark
of
Apple
Inc.
iPod
is
a trademark
of
Apple
Inc.,
registered in the
U.S.
and other countries.
iPhone
is
a trademark
of
Apple
Inc.
"Made for iPod" means that
an
electronic accessory
has
been designed
to
connect specifically
to
iPod and
has
been certified by
the
developer
to
meet Apple
performance standards.
"Works
with
iPhone" means that
an
electronic
accessory
has
been designed to connect specifically
to
iPhone and
has
been certified by the developer
to
meet Apple performance standards.
Apple
is
not
responsible for the operation
of
this
device or its compliance
with
safety and regulatory
standards.
English
I
59