User Manual
English
|
13
Connections
• Do not connect the changer control cable while the control unit is turned ON.
• Be sure to press the reset button after installation.
• Do not install an antenna of radio equipment or distribute the antenna cable near the
changer output cable, for this could cause malfunction with this unit.
The picture format selector switch must be set to the format of the connected monitor.
Set the KDC-CMP21V’s picture format selector switch to "PAL" when a PAL monitor is connected, to "NTSC"
when an NTSC monitor is connected.
Use video CDs of the same format as the format to which the KDC-CMP21V is set.
• No picture will appear if the KDC-CMP21V’s video output format is not the same as the monitor’s picture format.
• The top and bottom of the picture may be cut off or a black stripe may appear if the video CD’s format is different from the
KDC-CMP21V’s video output format.
Picture format selector switch
"NTSC"
"PAL"
D Changer control cable (5m)
Control unit (optional)
E Video cable (Black) (4m)/
Parking senser cable (Green) (6m)
Monitor unit (optional)
To parking brake detection
switch harness of car
For the sake of safety, be sure
to connect the parking sensor.
F Harness ties
Fix the harness tie close
to its connector.
Using the Relay Connector (Accessory G)
1
2
Detection wire
Vehicle
harness
3
Relay
connector
4
5
Cable clamp
Lid
Conductive metal
1 Plug the vehicle's harness into the relay
connector.
2 Plug the parking brake detection wire
into the relay connector.
3 Lock the cable clamp.
4 Press down using pliers until the
conductive metal is even with
the plastic surface.
5 Lock the lid.
1.KDC-CMP21VEnglish.indd 04.3.4,10:02AM13