user manual

60
13 MEMORY FEATURES
■ Memory Scroll
1 Press [M.IN] to enter Memory Scroll mode.
• The memory channel that was last selected
appears.
2 Turn the MULTI/ CH control, or press Mic [UP]/
[DWN] to step through the memory channels.
• You can also change channels by entering a
3-digit number, such as 012, using the
numeric keys, then pressing [ENT].
3 To exit Memory Scroll mode, press [CLR].
• The transceiver re-displays the memory
channel or VFO frequency that was
selected before you activated Memory
Scroll.
Note: Do not press [M.IN] again after entering Memory Scroll
mode. Pressing [M.IN] results in over-writing the current VFO
data to the memory channel you selected.
■ Temporary Frequency Changes
After retrieving frequencies and associated data in
Memory Recall mode, you can temporarily change
the data without overwriting the contents of the
memory channel.
1 Access Menu No. 06B and select ON.
• Skip this step when changing only the
associated data (not the frequency).
2 Recall a memory channel.
3 Change the frequencies and associated data.
• Use only the Tuning control to select a
frequency.
4 If necessary for future use, store the changed
data in another memory channel. Refer to
“Channel ➡ Channel Transfer” {page 61}.
Note: Memory channel data can also be changed while using
the TF-SET function.
MEMORY-VFO SPLIT OPERATION
Under “ENHANCED COMMUNICATIONS” {page 31},
you learned about split-frequency operation using two
VFOs. Recalling a split-frequency channel is another
way to perform split-frequency operation. If you
access Menu No. 06A and select ON, you can also
use a memory channel and a VFO together for this
operation, as follows:
• RX: Memory channel
TX: VFO A or VFO B
• RX: VFO A or VFO B
TX: Memory channel
To use a memory channel for receiving:
1 Access Menu No. 06A and select ON.
2 Press [A/B] to select the VFO that you will use for
transmitting.
•“tA” or “tB” appears to show which VFO is
selected.
3 Select the frequency for transmitting.
4 Recall a memory channel by pressing [VFO/M].
5 Turn the MULTI/ CH control to select a memory
channel to receive.
6 Press [SPLIT].
7 The VFO A frequency appears on the sub-display.
If you want to use the VFO B frequency to
transmit, press [SPLIT] again.
8 Press [SEND] or Mic [PTT] to transmit on the
frequency shown on the sub display.
9 Press [SPLIT] to exit the SPLIT operation.
• If Split operation is still selected using VFO A or
VFO B, press [SPLIT] again to exit Split
operation.
To use a memory channel for transmitting:
1 Access Menu No. 06A and select ON.
2 Recall a memory channel by pressing [VFO/M].
3 Turn the MULTI/ CH control to select a memory
channel to transmit.
4 Press [VFO/M] to return to VFO mode.
5 Press [SPLIT]. The other VFO frequency appears
on the sub display for transmission (Normal SPLIT
operation).
6 Press [SPLIT] again. The memory channel you
selected in step 3 appears on the sub-display for
transmission.
7 Press [SEND] or Mic [PTT] to transmit on the
frequency in the memory channel.
8 Press [SPLIT] to exit SPLIT operation.