BL760 series BL770 series
Use your blender for soups, drinks, pâtés, mayonnaise, breadcrumbs, biscuit crumbs, chopping nuts and crushing ice. Use your mill (if supplied) for milling herbs, nuts, coffee beans, spices and purées. ● ● ● ● ● before using your Kenwood appliance Read these instructions carefully and retain for future reference. Remove all packaging and any labels. Wash the parts: see ‘care and cleaning’.
● ● ● ● ● to use your blender Important - UK only The wires in the cord are coloured as follows: Blue = Neutral Brown = Live. The appliance must be protected by a 13A approved (BS1362) fuse. 1 Fit the sealing ring to the blender blade unit marked – ensuring the seal is located correctly in the grooved area. ● Leaking will occur if the seal is damaged or incorrectly fitted. 2 Clip the blade unit into the base .
● ● ● ● NOTE: The pre-program lights will flash under the following circumstances The power unit is plugged in but the goblet is not fitted to the power unit. The goblet is removed from the power unit without switching the speed control to “0”. The power unit will not operate until the control is turned to “0” and a speed is reselected. ● ● When making mayonnaise, put all the ingredients, except the oil, into the blender. Remove the filler cap.
to use your mill (if supplied) 7 After milling, you can replace the blade assembly with the mill lid. 1 Put your ingredients into the jar. (Refer to the mill recommended usage chart). 2 Fit the sealing ring into the mill blade unit marked – ensuring the seal is located correctly in the grooved area. ● Ensure that the seal is fitted correctly. 3 Then clip the blade unit into the mill base . 4 Turn the mill blade assembly upside down. Lower it into the jar, blades down.
2 Remove and wash the sealing ring. 3 Don’t touch the sharp blades – brush them clean using hot soapy water, then rinse thoroughly under the tap. Don’t immerse the blade unit in water. 4 Leave to dry upside down. IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste.
Head Office Address: Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK www.kenwoodworld.
