Refrigerator User Manual

LEVELING AND DOOR CLOSING

To avoid vibration, the unit must be leveled, if necessary,

adjust the Leveling Legs to compensate for unevenness

of the floor. The front should be slightly higher than the

rear to aid in door closing.

Your refrigerator has two Front Leveling Screws - one on

the right and one on the left. if your refrigerator seems

unsteady or you want the doors to close more easily,

adjust the refrigerator's tilt using the instructions below:

1. Plug refrigerator power cord into a 3-prong grounded

outlet. Move the refrigerator into its final position.

2. Remove the base grill. See BASE GRILL

INSTRUCTIONS on page 8. The two Leveling Screws

are located on the bottom of the refrigerator on either

side (see Fig. 39).

3. insert a flat screwdriver in slots to adjust the Leveling

Screws (Fig. 39). Turn the leveling screw clockwise

to raise that side of the refrigerator or counterclockwise

to lower it. it may take several turns of the Leveling

Screw to adjust the tilt of the refrigerator.

NOTE: Having someone push against the top of the

refrigerator takes some of the weight off the Leveling

Screws. This makes it easier to adjust the screws.

Fig. 39

DOOR ALIGNMENT

If the space between your doors is uneven, follow the

instructions below to align the doors:

1. Gently pry off the Top Hinge Cover with a flat head

screwdriver and remove. Loosen the Top Hinge Bolts

using a 10mm or 13/32-in. socket wrench or

open-end wrench.

2. Have someone hold the freezer door so the space

between the two doors is even, and retighten

the top hinge bolts.

3. Replace the Top Hinge Cover.

4. Open both doors again and check to make sure

that they close easily. If not, tilt the refrigerator

slightly more to the rear by turning both Leveling

Screws clockwise. It may take several more turns,

and you should turn both Leveling Screws the

same amount.

5. Replace the base grill.