Installation guide

ManualsBrandsKenmore Manualswall ovenOfficial Kenmore gas wall oven

INSTALLATION AND SERVICE MUST BE PERFORMED BY

A QUAUFiED INSTALLER.

iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

if the information in this manuam is not fommowed exactmy, a fire or expmosion may resumt

causing property damage, personam injury or death.

FOR YOUR SAFETY:

-- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any

other appliance.

-- WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any emectricamswitch; do not use any phone in your buimding.

lmmediatemy cairnyour gas suppmier from a neighbor's phone. Fommowthe gas suppmier's instructions.

if you cannot reach your gas suppmier, cairnthe fire department.

-- lnstammation and service must be performed by a quamified instammer,service agency or the gas

Additional Safeguards

Do not install wall oven

beneath a countertop

The oven vent shall not be located

below 36" from floor_

11/2"

(3.8 cm)

Allow at least 19-3/8" clearance for the oven door to

open completely

Drill a 1_/2'' /eter hole

for gas hook up

Figure 1

Wall Oven 10 (25.4) rain. 37_/2(95.3) rain. 24 (61) min. 20 (50.8) 7'/8 (18.1) 22 (55.9) rain. 23_/2(59.7)

27_/2(69.9) max. 38 (96.5) max. 22_/2(57.2) max.

All dimensions are stated in inches and (cm).

NOTE: Wiring diagram for this appliance is enclosed in this booklet.

Printed in United States

P/N 318201552 (0507) Rev B

English - pages 1-10

Espano[ - paginas 11-19

Wiring Diagram - pages 20

Summary of content (20 pages)

PAGE 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUAUFiED INSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. causing if the information in this manuam is not fommowed exactmy, a fire or expmosion property damage, personam injury or death. may resumt FOR YOUR SAFETY: --- Do not store or use gasoline or other other appliance.
PAGE 2
Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the appliance. 2. Remove all packing material and literature from the oven and broiler compartments before connecting gas and electric supply. 3. Observe all governing (:odes and ordinances. 4. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions with your Use and Care Guide for future reference.
PAGE 3
I. Carpentry Refer to figure I for the dimensions applicable to your appliance, and the space necessary to receive the oven. The oven support must be solid plywood or similar material, and the surface must be leveled from side to side and from front to rear. Corners must be square. Support surface must be able to support 150 pounds and must be level with bottom of cabinet opening. 2. Connect Electricity to Gas Wall Oven For personal safety, these appliances properly grounded.
PAGE 4
OvenDoor_, CenterVentTrim Mounting -._ _Extension Screws Mounting Screws Decorative Trim........ Panel Figure 4 4. Cabinet Figure 5 Installation The wall oven can tip when the door 5. Alternate is open. The mounting screws supplied with the wa!l oven must be attached to the cabinet and the appliance to prevent injury to persons. tipping This is a lY2 cavity oven. To install it into an existing 2 cavity opening with dimensions 42-1/8" height by 22Y2" width, follow the instructions below.
PAGE 5
. Provide an Adequate Gas Supply Important: Read these instructions carefully before connecting this unit to a gas supply. 7. Connection to gas (see figure 7) Pressure Regulator Shut-Off Valve The units covered in these instructions are designed to operate on natural gas at 4" of manifold pressure or on LP gas at 10" of manifold pressure.
PAGE 6
IMPORTANT; A pipejointsealantresistanttothe action of LPGasmustbeusedonallpipeconnections. Disconnect the oven and its individual from the gas st@ply piping test greater than Y2 psig, system during shutoff valve any pressure B. Adjust Oven Burner Orifice (see figure 9} Using a _/2" wrench, turn the adjustable spud clockwise approximately 2Y_turns until it is snug against the gas mixer pin. Do not overtighten (see figure 9).
PAGE 7
9. Natural Gas Conversion Convert the Pressure Regulator for use with NaturaJ Gas (see figure 8) A. Remove the cap from the pressure regulator. B. Remove the plunger. C.Turn the plunger upside down with tile enlarged end UP. D. Replace the plunger inside the regulator. The letters NAT or 4" W.(. should be visible on the exposed end of the plunger. E. Replace the cap on tile pressure regulator. F. Adjust the oven burners.
PAGE 8
11. LeveJing 1. 2. the WaNJ Oven Install an oven rack in the center of the upper oven (see Figure 13). Pla(e a level on the rack. Take 2 readings with the level placed diagonally in one direction and then the other. Use wood shims under the wall oven to level if necessary. Model and Serial Number Location The serial plate is located on tile left side inner trim of the oven.
PAGE 9
Notes
PAGE 10
Notes 10
PAGE 11
LA [NSTALAC[6N Y EL SERV[C[O DEBEN SER REAUZADOS POR UN [NSTALADOR CAUHCADO. [MPORTANTE: GUARDE ESTAS [NSTRUCC[ONES PARA USO DEL INSPECTOR EL[_CTR[CO LOCAL. LEA Y GUARDE ESTAS [NSTRUCC[ONES PARA FUTURAS REFERENC[AS Si todas las instrucdones de _ste manual no son observadas a la letra, se puede ocurrir incendios o exp[osiones que pueden causar daffos materia[es, [esiones o [a muerte.
PAGE 12
Notas importantes para e[ insta[ador: • No almacene alimentos u otros objetos de interns para los ni_os en aJacenas ubicadas endma de Ja estufa o en Ja guarda posterior de esta. Los r%os pueden quemarse o lastimarse seriamente si se suben en la estufa para alcanzar estos objetos. • No guarde o haga uso de gasoHna o otros vapores y t_quidos inflamabJes acerca de est_ o cuatquier aparato. Sepuederesultaren incendioso explosiones. 1.
PAGE 13
2. Cone×ion Ei ctrica 3. Ajustando Como medida de seguridad personal, est_ artefacto debe conectarse a tierra correctamente. Para su protecci6n contra choques electricos este aparato ha sido equipado con un enchufe de tres paras con conexi6n a tierra apropiada. No remueva la pata redonda de tierra de es enchufe. Preferido del Homo Este modelo de homo cuenta con un ajuste de altura de 1 Y2" (vet figura 3).
PAGE 14
Marco de ventilation Tornillos de montaje Tornillos de montaje Marco decorativo bajo ...... horno decorativos Figura 4 4. instaladon Figura 5 del gabinete E[ homo de pared puede indinarse cuando [a puerta esta abierta, Los soportes de montaje que vienen con e[ homo de pared deben de estar ajustadas a[ armario y a[ aparato para evitar que e[ homo de pared se incline y ocasione quemaduras graves. 5.
PAGE 15
5. Provea un adecuado suminBtro de gas 7. Conexi6n tmportante: Lea estas instrucciones cuidadosamente antes de conectar esta unidad al suministro de gas. de[ gas (yea figura 7) \ \ Regulador de presion l Las unidades alas cuales se refieren estas instrucciones han sido dise_adas para operar con gas natural de 4" WC o gas LP de 10" WC.
PAGE 16
tMPORTANTE: Paralasunionesdetuberiadebeusarse un sellante de union de tuberia que sea resistente a la acciOn del gas LP. Desconecte eJ homo y su v_Ivula de cierre individual del sistema de tuberia del suministro de gas durante cualquier ensayo de presiOn del sistema en ensayos de presiOn superiores a 1/2 psig (3.5 kPa o 14" colomna de agua). B.
PAGE 17
9. Conversion de Gas Natural Demasiado aire harla qua la llama se alejara del quemador. Unaentradainsuficientedeairecausarlala coloracion amarilla del borde extemo de la llama yla formacion de hollin. Convertir ]a unidad de Gas LP/Propano a Gas NaturaJ, proceda de ta siguiente manerar (vea figura 8) A. Rernueva la tape del regulador de presi6n. B. Remueva el desatascador. Recuerde, el homo sere despacho de la f_brica preparado pare trabajar con gas natural, a menos qua se especifiquealgodiferente.
PAGE 18
11. Asegurese de que ei homo pared est& a nivel 1. 2. Cuando se hart realizado de conexi6n de todos los sistema AsegOrese que todos los controles est&n en la posici6n de OFF (apagado). Instale una rejilla al centro del horno superior (yea la Figura 13). Ponga un nivel por encima de la rejilla. Lea 2 veces, una vez (:on el nivel a la position de lado a lado, y otra vez de atras hacia adelante. Utilice trozo de madera o cu¢_aspot debajo del homo de pared para nivelar, si sea necesario.
PAGE 19
Notas 19
PAGE 20
BAKE IGNITER ENCENDID0 EiECFRONIC ()VEIN CON]RG CONTROL DE HORNO ELECTRONICO ES 350/ES555 DE HORNEAR d_ ]l ] I BA,