Range User Manual

Before You Call • Solutions to common problems
Problem Solution
Oven smokes excessively when broiling. ° Incorrect setting. Follow broiling instructions in Setting Oven Controls
section.
* Be sure oven door is opened to broil stop position when broiling.
* Meat too close to the broil element. Reposition the broil rack to provide
proper clearance between the meat & the element. Preheat the broil
element for searing.
° Meat not properly prepared. Remove excess fat from meat. Cut remaining
fatty edges to prevent curling, but do not cut into lean.
* Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
Flames inside oven or smoking from oven * Excessive spillovers in oven. For example this will happen for pie
vent. spillovers or large amounts of grease left on the oven bottom. Wipe up
excessive spillovers before starting oven. If flames or excessive smoke
are present see Broil in Setting Oven Controls section.
[]
Oven control panel beeps & displays ° Oven control has detected a fault or error condition. Press STOPkey pad to
any F code error, clear the error code. Try Baize or Broil function. If the F code error repeats,
remove power from appliance, wait 5 minutes and then repower appliance
and set clock with the correct time of day. Try Baize or Broil function again.
If the fault recurs, press sToP to clear and call 1-800-4-MY-HOME® for
assistance (See back cover).
Flex Clean does not work. * Oven control not set properly. Review instructions in Flex Clean section.
Soil not completely removed after Flex * Flex Clean was interrupted. Review instructions in Flex Clean section.
Clean.
° Excessive spillovers on oven bottom. Remove before starting Flex Clean.
Failure to clean soil from the oven frame, the door liner outside the oven
door gasket and the small area at the front center of the oven bottom.
These areas are not in the self-cleaning area, but get hot enough to burn
on residue. Clean these areas before the self-cleaning cycle is started.
Burned-on residue can be cleaned with a stiff nylon brush and water or a
nylon scrubber. Be careful not to damage the oven gasket.
Oven racks discolored. * Oven racks left in oven cavity during Flex Clean. Always remove oven racks
from oven cavity before starting a self-clean cycle. Clean by using a mild,
abrasive cleaner following manufacturer's instructions. Rinse with clean
water, dry and replace in oven.
Convection fan does not rotate. ° Oven door is open. Convection fan will turn off if oven door is opened when
Convection is active. Close oven door.
37