Owners manual
Table Of Contents
- KENMORE LIMITED WARRANTY
- Before setting oven controls
- Oven Controls
- Minimum & maximum control settings
- Setting the Clock
- Changing between 12 or 24 hour time of day display
- Setting Continuous Bake or 12 Hour Energy Saving
- Setting Oven Timer
- To Set Add 1 Minute Feature
- Setting the Oven Lockout
- Setting Silent Control Operation
- Setting Temperature display -- Fahrenheit or Celsius
- Operating Oven Lights
- Setting Cook Time
- Setting Delay Start
- Warm & Hold™
- Setting Bake
- Setting Broil
- Setting Convection Bake
- Setting Convection Roast
- Setting Convection Convert feature
- Setting the Slow Cook feature
- Cooking and Preparation tips for Slow Cook
- Restoring factory default settings
- Adjusting Oven Temperature
- Setting the Sabbath Feature (for use on Jewish Sabbath and Holidays)
- Self-Cleaning Operation
- Self-Cleaning Oven
- To Start the Self-Clean Cycle
- Stopping or Interrupting a Self-Cleaning Cycle
- Care and Cleaning
- Before You Call
10
Oven Controls
Setting the Clock
The key is used to set the clock. The clock may be set for
12 or 24 hour time of day operation. The clock has been preset
at the factory for the 12 hour operation. When the range is first
plugged in, or when the power supply to the range has been
interrupted, the time in the display will flash. Press . The
display will stop flashing.
Example: Setting the clock for 1:30:
1. 1 Press . CLO will appear in the display. )
2. Press 1 3 0 keys to set time of day. Press
3. Time of day will now appear in the display.
Changing between 12 or 24 hour time of day display
1. Press and hold for 7 seconds until 12Hr or 24Hr
appears in the display.
2. Press Self-Clean to switch between the 12 and 24 hour time
of day displays. The display will show either 12Hr of 24Hr
(figure)
3. Press to accept the change or press to reject.
4. Reset the correct time as prescribed in Setting the Clock
above. Note: if the 24 hour time of day was selected, the
clock will now display time from 0:00 through 23:59 hours.
Setting Continuous Bake or 12 Hour Energy Saving
The Timer on-off and Self-Clean keys control the Continuous
Bake or 12 hour Energy Saving features. The oven control has a
factory preset 12 Hour Energy Saving feature that shuts off the
oven control if left on for more than 11 hours and59 minutes. The
oven can be programed to override this feature for Continuous
baking.
To set the Continuos Bake or 12 Hour Energy feature:
1. Press and hold Timer on-off for about 7 seconds. The
dashes will change to show either 12Hr OFF or Stay On in
the display and the control will beep once.d
2. Press Self-Clean to switch between the 12Hr Energy saving
and Continuous Bake features. Note: 12 Hr OFF indicates
the control is set for the 12 hour energy saving mode. Stay
On indicates the control is set for the Continuous Bake
mode.
3. Press to accept your selection and the display will
return to show the time of day.
Setting Oven Timer
The Timer on-off controls the Timer and serves as an extra timer
that will beep when the set time has run out. It does not start or
stop cooking. The Timer feature can be used during any of the
other oven control functions, except Self-Clean and Sabbath.
To set Timer (example 5 minutes)
1. Press Timer on-off. When dashes appear in the display
press the number 5 key (for this example) and press .
The time will begin to count down.
2. Note: If the start key is not pressed timer will return to time
of day after 30 seconds.
3. When timer runs out, End and TIMER show in display. The
clock will beep 3 times every 30 seconds until Timer on-off
is pressed. Press Timer on-off to cancel the timer at any
time. Once canceled the display show the time of day.