Installation guide

Installation Instructions
B2.__.USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
B3.__.ADAPTING MICROWAVE
BLOWER FOR OUTSIDE TOP
EXHAUST
1. Remove and save
screw that holds
blower plate to
microwave.
2, Lift up the
blower plate.
B_.ckof
_°'_ Microwave
Screw
3. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
"
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the
blower is removed and re-installed.
4, Roll the blower unit 90 ° so that fan blade
openings are facing toward the top of the
microwave.
Roll
15