Installation guide

ELECTRICAL CONNECTION
Power Supply Cord Direct Wire
Ch)
4
Fire Hazard
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Connect neuiral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Disconnect power before making electrical connections.
Fire Hazard
Use 10 gauge copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Electrical Connection Options
{—
1. Choose electrical connection type
2. Remove terminal block cover
Power supply cord 4-wire receptacle
O (NEMA Type 14-30R):
] ll Go to "Power Supply Cord Connection".
U
Power supply cord 3-wire receptacle
(NEMA Type 10-30R):
Go to "Power Supply Cord Connection".
4-wire direct connection:
Go to "Direct Wire Connection’.
3-wire direct connection:
Go to "Direct Wire Connection’.
NOTE: If local codes do not permit connection of a
cabinet-ground conductor to neutral wire, go to “Optional
3-wire connection.” This connection may be used with
either a power supply cord or a direct wire connection.
Before you start, disconnect power. Remove hold-down
screw (D) and terminal block cover (A).
A. Terminal block cover
B. External ground conductor screw
C. Center terminal block screw
D. Hold-down screw
E. Neutral ground wire
F. Hole below terminal block cover