Installation guide

ManualsBrandsKenmore Pro Manualswall ovenOfficial Kenmore Pro electric oven

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.

READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasohne or other flammabJe vapors and Jiquids in

the vicinity of this or any other appliance.

Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing

easier. The first step of your installation should be to measure your current cutout dimensions and

compare them to the cutout dimensions chart beJow for your model You may find Jittle or no cabinet

work being necessary.

Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in

oven. These spacers center the oven in the space provided. The oven must be centered to prevent

excess heat buiJdup that may result in heat damage or fire.

NOTES:

1. Cutout base must be capable of supporting 200 pounds (90 kg). _]T-.___

2. Allow at least 21 " (53,3 cm) clearance in front 1" (2.5 cm) - ' "_--__-----_ _

of oven for door depth when it is open. Min. _-

3. Dimension G (cutout

depth) is critical to the _ <L

proper installation of the _ _C. -._ _ -.....

. . .._ _.._. / ._, Hole

built-In oven. If the oven " F -'_ _... -_G LL- , ....

. . "_--._._,._ .--_ : TOF _able

decorative trim does not / _ --.:.... ; /

, , /

butt against the cabinet R 1_" H F _

. . . _ L.I ._ _J

or If noise IS heard on , i

cm) i ,,

convection models verify i _;__ 3

dimension G to assure it is I ";_ _" .'- ""-- t7 6 cm'

the required depth. "_. _ _ I,,_-" _ /, {..,_-'-;_H:_----._ '] '

Doo;Open _ ............./I Spacer I r_ _. _" _ [

(see note 2).,.. ................ /D t _ _ _] 1/,4,, _ '

""-... "_-_ _ (3.2 cm) "1

A _ _ _-_-_ Min.Jn./_,/ ,

2"cmlWideWood-- a'

4. For a cutout height greater than 27W_?' (70.6 cm) add Spacerif Needed V Junc!:lon !_OX

one2"(5cm) wide wood shim of appropriate height to * Suggested distance from floor is 31"(78.7cm).

each side of the opening under the appliance side rails. Minimum required distance is4 1/2"(11.4 cm)

Figure 1 - Single Wall Ovens (Double ovens see Figure 2)

!!_;!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!_i_!iiiii(_iii_ili_ii__i,if!f_!i_ii_ii_ii_ii_ii ii i iiii iiiiliiliiiiiii_iili_!!_i '!_i!i_i!;i!;i!;i!i_i!;i!;i!;i!i_i!;i!;i!;i!i_i!;i!;i!;i!i_i!;i!;i!;i!i_i!;i!;i!;i!i!iiiiil_iri!_i!_i!r i!_i!_i!_i_iiiiiiiiiiiiiiiiiiiii_i_iiii!!!iii_iii_iii_iii_iii_iii_iii_iii_iii_iii_iii_iii_iii_iii_iii!_{!

30" (76.2 cm) Wall Oven 30 (76.2) 29V_ (73.8) 28¼ (71.8) 24Y_ (62.2)

30" (76,2 cm) Wall Over] 28Y2 (72.4)

All dimensions are in inches (cm).

Printed in United States

29 (73.7) 23B (59.7) 27¼ (69.2) 28Y2 (72.4) 30I/s (76.5) Min

P/N 318201522 (0602) Rev. A

English - pages 1-10

Espahol - paginas 11-20

Summary of content (20 pages)

PAGE 1
iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. the vicinity FOR YOUR SAFETY: Do not store or use gasohne or other flammabJe vapors and Jiquids in of this or any other appliance. Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing easier.
PAGE 2
Do not oven. These spacers excess heat buildup remove spacers (if equipped) on the side center the oven in the space provided. that may result in heat damage or fire. walls The oven and/or must on the back of the built-in be centered to prevent I 1" (2,5 cm) Min. - 4._ Hole for , //_ble 3" (7.6 cm) Max. (DeOeO rnoO1_2i" "" (29'_1_'t) _---- 1¼" cm) Junction "'"'"'"'"" "" A _/ Spacer2" Box i(5 Spacer cm f)__/id i Need e_ NOTES: 1.
PAGE 3
Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the wall oven. 2. Remove all packing material from the oven compartments before connecting the electrical supply to the wall oven. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. 5. Oven door may be removed to facilitate installation. 6. THESE OVENS ARE NOT APPROVED FOR STACKABLE OR SIDE-BY-SIDE INSTALLATION.
PAGE 4
Electrical Shock Hazard • Electrical ground is required on this appliance. • Do not connect to the electrical supply until appliance is permanently grounded. • Disconnect power to the junction box before making the electrical connection. • This appliance must be connected to a grounded, metallic, permanent wiring system, or a grounding connector should be connected to the grounding terminal or wire lead on the appliance. • Do not use a gas supply line for grounding the appliance.
PAGE 5
You may not ground the oven through the neutral(white)wire ifoven isused in a new branch circuit installation (1996 NEC), mobile home, recreationalvehicle,or where localcodes do not permit grounding through the neutral(white) wire. When grounding through the neutral(white) wire is prohibited, you must use a 4-wire power supply cable. See Figure 4. Failure to heed this warning may result in electrocution or other serious personal injury.
PAGE 6
Do not lift the IMPORTANT oven by the door handle. 3. Insert the oven into the cabinet opening. Slide oven inward leaving 11/2"(3.8 cm) clearance between the oven and front of cabinet (see Figure 6). Pull the appliance cable through the hole for it in the cabinet and toward the junction box while moving the appliance inward. Mounting bracket released Oven removed from the cabinet Hole where to insert the tool Figure 7 "" Y2" (3.8 cm) clearance between unit Figure 6 4.
PAGE 7
6.Fortypicalundercounterinstallation ofanelectric built-inovenseeFigure below. Onlycertaincooktopmodelsmaybeinstalled overcertainbuilt-inelectric ovenmodels. Approved cooktops andbuilt-inovensarelistedbytheMFGIDnumberand productcode(seetheinsertsheetincludedintheliteraturepackage andcooktopinstallation instructions forthe dimensions). Cabinet side filler panels are necessary to isolate the unit from adjoining cabinets.
PAGE 8
FigureI 0 - TYPICAL UNDER COUNTER INSTALLATION OF A SINGLE ELECTRICBUILT-IN OVEN WITH A GAS COOKTOP ABOVE
PAGE 9
6. Leveling I. the Wall Oven 2. Install an oven rack in the center of the upper oven (see Figure 11). Place a level on the rack. Take 2 readings with the level placed diagonally in one direction and then the other. Use wood shims under the wall oven to level 3. if necessary. Repeat in the lower oven if you have a double cavity wall oven. If the level indicates that the rack is not level, use wood shims to reach a compromise for both ovens. 7.
PAGE 10
Notes 10
PAGE 11
LA INSTALACION Y EL SERVICiO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO, IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL iNSPECTOR LOCAL DE ELECTRICiDAD, LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCiA FUTURA, PARA SU SEGURIDAD: en la proximidad No almanece de este o de cualquier otro ni utilice El primer paso para su instaladbn debe de set el de medir que se indkan en el cuadro de dimensiones del hueco trabajo de carpinteria sera necesario.
PAGE 12
_t__ No quite los separadores de los muros laterales o/y de la parte posterior del horno empotrado. Estos espaciadores centran el homo en el espacio provisto. El homo debe estar centrado para prevenir una concentraci6n excesiva de calor que podria resultar en daffos por el calor o un incendio. 1" (2.5 cm) Min. 4_ i Puerta H 48 5/8" (123.5 cm) 3" (7.6 cm) Max. 11V2" J Abierta ° (29.
PAGE 13
Notas importantes para el instalador Lea todas las instrucciones antes de instalar el horno. 2. Saque todo el material usado en el embalaje del compartimiento del homo antes de conectar el suministro electrico o de gas a la estufa. Observe todos los cOdigos y reglamentos pertinentes. Deje estas instrucciones con el consumidor. La puerta del homo se puede retirar para facilitar la instalaciOn. ESTE HORNO NO EST/_ APROBADO PARA LA INSTALAClON APILABLE O DE LADO A LADO. 3. 4. 5. 6.
PAGE 14
Riesgo de choque Donde los cOdigos locales permitan conectar el conductor de puesta a tierra del el_ctrodom_stico al neutral (blanco) (vea figura 3): (Un cordon flexible o cable de 3 conductores debe de ser reemplazado con un cordon flexible o cable de 4 conductores donde la conexi0n del conductor a tierra al neutro esta electrico , Una puesta a tierra se require en este aparato. No Io conecte a la corriente el_ctrica hasta clue el aparato haya sido puesto a tierra.
PAGE 15
Si el horno se usa en una instalaci6n de circuito de ramal nuevo (1996 NEC), en una casa rodante, en un vehiculo para recreaci6n o si los c6digos locales NO permiten la conexi6n a tierra a trav&s del cable neutral (blanco) (ver figura 4): I. Desconecte el suministro 2. En el interruptor juntas: conectar 5. instaladon El homo el_ctrico. Cable desde el suministro de energia desnudo_ I]x\ __mbre irq ,ambre verde o _ desnudo _/_ blanco "_'_'_-- puede inclinarse Instrucciones de instalaciOn de
PAGE 16
No levante f el homo por la manija de la puerta. IMPORTANTE -X Soporte de monta e Bracket1 I nsta ado en el del I gabinete 3.1nsertar el homo en la abertura del gabinete. Deslizar el homo hacia dentro dejando lY2" (3,8 cm) de espacio libre entre el homo y la parte delantera del gabinete (ver la Figura 6). Empujar el cable blindado a traves del orificio del gabinete y hacia la caja de paso mientras se desliza el accesorio hacia adentro. Iqor n D_ inete Homo soporte de montaje \ I liberado Introd
PAGE 17
6. Para una instalaci6n tipica de un homo electrico incorporado debajo del mostrador, SOlo ciertos modelos de tapas de cocina se pueden instalar sobre ciertos modelos de hornos electricos empotrados. Las tapas de cocina y los hornos empotrados se mencionan pot su numero de identificaciOn MFG ID y cOdigo de producto (vet la planilla que se incluye en el paquete de literatura y las instrucciones de instalaciOn de la cocina donde est_fin detalladas las dimensiones).
PAGE 18
_ 18"(45.
PAGE 19
6, Asegurese pared 1. 2. 3. est de que el horno 7. Verificacion de del funcionamiento Su modelo esta equipado con un Control Electr6nico de Homo. Cada una de las funciones ha sido controlada en fabrica antes del despacho. Sin embargo, le sugerimos verificar el funcionamiento de los controles electr6nicos una vez mas. Consulte la Guia de Uso y Cuidado para ver el funcionamiento del homo. a nivel Instale una rejilla al centro del homo superior (vea la Figura I 0).
PAGE 20
Notas 20