Installation guide

Installation Instructions
STEP 15 |DISHWASHER WET TEST
Turn on power supply (or plug power cord into outlet, if
equipped).
Turn dial to Normal “Wash” position.
Close door.
Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
and power are turned on.
Check for leaks under the dishwasher. If a leak is found,
turn power supply off, then tighten connections. Restore
power after leak is corrected.
Check for leaks around the door. A leak around the door
could be caused by door rubbing or hitting against
adjacent cabinetry. Reposition the dishwasher if necessary.
See Step 9.
The dishwasher will drain and turn off about 5 to 7 minutes
after the first fill. Check drain lines. If leaks are found, turn
power off at the breaker and correct plumbing as
necessary. Restore power after corrections are made. See
Step 12.
Open dishwasher door and make sure most of the water
has drained. If not, check that disposer plug has been
removed and/or air gap is not plugged. See Step 13. Also
check drain line for kinking.
Run the dishwasher through another fill and drain cycle.
Check for leaks and correct if required.
At the end of drain, open door and turn dial to OFF
position.
STEP 16 |REPLACE TOEKICK
Screw Holes
2-Piece
Toekick
Adjust Up |
or Down
ae
Figure Y
* Place 2-piece toekick against the legs of the dishwasher.
* Place the inner toekick piece (with slots) against the toekick
bracket. The slots should align with toekick bracket screw
holes. Allow the toekick to touch the floor.
* Place larger toekick over the inner piece and install 4
toekick screws.
« Use additional 2 screws that are provided for installations
over 33-1/2” high.
« Use both toekick pieces for all installation heights.
STEP 17_|LITERATURE
Be sure to leave complete literature package and installation
instructions with consumer.