Datasheet

© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 [phone] • www.kemet.com F3097_R47_X1_440 • 10/22/2014 4
Metallized Polypropylene Film EMI Suppression Capacitors
R47 Series, Class X1, 440 VAC, 110ºC (Automotive Grade)
Performance Characteristics
Dielectric Polypropylenelm
Plates Metal layer deposited by evaporation under vacuum
Winding Non-inductive type
Leads Tinned wire
Protection Plasticcase,thermosettingresinlled.BoxmaterialissolventresistantandameretardantaccordingtoUL94.
Related documents IEC 60384-14, EN 60384-14
Rated Voltage (V
R
) 440 VAC (50/60 Hz), 1,000 VDC
Capacitance Range 0.0047 µF to 2.2 µF
Capacitance Values E6/E12 series (IEC 60063)
Capacitance Tolerance ±10%, ±20%
Temperature Range -40ºCto+110°C
Climatic Category 40/110/56 IEC 60068-1
Approvals ENEC, UL, cUL
DissipationFactor(tanδ) ≤0.1%(0.06%*)@1kHz,+25°C±5°C(*typicalvalue)
Test Voltage Between Terminals
The 100% screening factory test is carried out at 2,700 VDC/1,700 VAC. The voltage level is selected to meet the
requirements in applicable equipment standards. All electrical characteristics are checked after the test. It is not
permitted to repeat this test as there is a risk to damage the capacitor. KEMET is not liable in such case for any failures.
Insulation Resistance
Measuredat+25°C±5°C,accordingtoIEC60384–2
Minimum Values Between Terminals
Voltage Charge Voltage Charge Time C≤0.33μF C>0.33μF
100 VDC 1 min ≥1•10
5
MΩ ≥30,000MΩ•µF
In DC Applications Recommendedvoltage≤1,000VDC
Qualication
Automotive Grade products meet or exceed the requirements outlined by the Automotive Electronics Council. Details regarding test
methodsandconditionsarereferencedindocumentAEC–Q200,StressTestQualicationforPassiveComponents.Foradditional
information regarding the Automotive Electronics Council and AEC–Q200, please visit their website at www.aecouncil.com.