Assembly Instruction

Failure to read and carefully follow all instructions
could result in fire or serious bodily injury or death.
To avoid in shock, fire or serious bodily injury or
death it is very important that the electricity servicing the fixture is turned
off before and during installation.
CAREFULLY READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY. Because this fixture is
connected to live electrical wires, it is strongly recommended that you use a
qualified electrician.
THIS FIXTURE SHOULD TAKE APPROXIMATELY 10 MINUTES TO ASSEMBLE.
MAKE SURE ALL PARTS ARE FIRMLY TIGHTENED.
TOOLS: You will need following tools or equipment:
ladder, screwdriver, adjustable wrench, wire cutters and
pliers.
UNPACK THE FIXTURE: You should have received the
following parts in the package: canopy, chain,Fixture
Lamp. To protect the finish, place all parts on a soft
surface.
MOUNTING HARDWARE PACKAGE: (2) Expanding nut, (2)
1-4 x 1-1/4" screw, crossbar, green ground screw and (2)
wire connectors.
FIXTURE ASSEMBLY:
Determine the length of chain required to hang the fixture at
the desire height, remove or add chain as desired. Using
pliers, open one end link of chain and attach to screw collar
loop, attach the end link of the chain
to chain loop and then
Thread fixture wire and Supply Ground Wire UP through
every other link of chain.
secure with small nut.
TO SPREAD A LINK OF CHAIN
Use a pair of pliers and a screwdriver as shown above,
being careful to warp the jaws of the pliers with cloth to
protect the finish of the chain.
ASSEMBLY INSTRUCTION:
READ AND SAVE THE INSTRUCTIONS.
WARNING
WARNING
Wire connectors
2pcs
Canopy
Outlet Box
Ground Screw
Green Ground Wire
1-4 Screw,
Supplied with
Mounting Hardware pack
Crossbar
Chain Loop
Chain
Chain Loop
All Rights Reserved.
Page 1 Of 6