Operation Manual

33
6.2.14 Velocity Offset
This parameter sets the velocity value used, when Velocity Compression is
lower than 10.
For example to get a “No-Velocity” Organ type of playing feeling, set Velocity
Compression to 0 and adjust the velocity level with this parameter to 100 or
any other wanted level of velocity. If Velocity Compression is set to 10,
Velocity Offset has no effect.
6.2.15 Zone Transpose
This parameter sets the amount of transposition for the selected zone. The
available range is three octaves up or down (+/-36 semitones).
Note:
To set the master transpose, press the TRANSPOSE button and set the
value.
6.2.16 Transmitting Volume (Ext only)
This parameter determines if an initial MIDI Volume message will be
transmitted (On) to an external MIDI device or not (Off) when a SETUP is
recalled.
Note:
In a zone set to External or Both, moving the faders will still transmit
volume messages even if TX Volume is set to Off.
6.2.17 Volume
This parameter sets the volume level for the selected zone. The value can be
changed by using the FADER or VALUE buttons.
For External zones, when the TX Volume is “Off”, this page won’t be
displayed.
6.2.18 Transmitting Control Change (Ext only)
This parameter determines if the Pan/Fine Tune/Control Knob settings will
be transmitted (On) via MIDI or not (Off) when a SETUP is recalled.
Note:
In a zone set to External or Both, moving the Control Knobs will still
transmit the values even if TX CC is set to Off.
6.2.19 Pan
Int: This sets the pan-pot (right and left balance).
Ext: This sets the pan-pot value that will be transmitted to external sound
modules. If the TX CC is “On”, the value is transmitted when a SETUP
is recalled. When the TX CC is “Off”, this page won’t be displayed.
The value changes from L63 to R63.
1 Concert Grand
Vel Offset = 100
3External
TX Cntrl# = On
1 Concert Grand
Pan = 0
1 Concert Grand
Zone Trans.= 0
3External
TX Volume = On
1 Concert Grand
Volume = 0