Operating instructions

Table Of Contents
- 6
Drain the fresh water tank and flush out
deposits.
Clean the fresh water filter.
Clean the swimmer.
Clean the fluff filter.
During long operating pauses: Carry
out refill charging for the battery.
Check battery poles for oxidation, brush
off if necessary. Ensure firm seating of
the connection cable.
Clean the seals between waste water
tank and cover and check for tightness,
replace if required.
Check the acid density of the cells if the
batteries are not maintenance-free bat-
teries.
For long periods of disuse, only turn the
device off when the battery is fully
charged. Fully recharge the battery at
least every month.
Have the prescribed inspection carried
out by the customer service.
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
Open the cover of the waste water tank.
1 Lock hook
2 Fluff filter
3 Float
4 Swimmer casing
Detach locking hooks.
Pull off the float housing in a downward
direction.
Remove the float from the float housing
and clean it.
Clean the fluff filter.
Reassemble the parts in the reverse se-
quence.
Open the cover of the waste water tank.
1 Coarse dirt sieve
Pull the coarse dirt filter off in an upward
direction.
Rinse off the coarse dirt filter under run-
ning water.
Reinsert the coarse dirt filter into the
waste water tank.
Remove the vacuum bar.
Unscrew the star grips.
Remove the plastic parts.
Remove the vacuum lips.
Insert new vacuum lips.
Insert the plastic parts.
Screw in and tighten the star grips.
Lift the cleaning head.
Press the pedal for changing the brush-
es downward beyond its resistance.
Pull the disc brush out of the side below
the cleaning head.
Hold the new disc brush under the
cleaning head, push upward and lock.
In case of danger of frost:
Empty the fresh and dirt water reser-
voirs.
Store the appliance in a frost-protected
room.
Monthly
Yearly
Maintenance Works
Maintenance contract
Clean the float and fluff filter.
Cleaning the coarse dirt filter
Replacing the vacuum lips
Replacing the disk brushes
Frost protection
16 EN