Use and Care Manual
English 5
ASSEMBLY INSTRUCTIONS
WATER SUPPLY (Cold Water Only)
Required Tools (included)
Hardware (included)
Description
7/16" (or 11mm) Wrench Stamped
Description Purpose Illustration Qty
A
Joint Joint Assembly 4
B
1/4" Nut Joint Assembly 4
C
1/4" Bolt Joint Assembly 4
D
3/8" Bolt Joint Assembly 2
E
Knob Joint Assembly 2
F
Anchor
Rivet
Nozzle Holder Assembly 4
CAUTION
When connecting to water supply mains, local
regulations of your municipal water company
must be observed. In some areas connecting
directly to public drinking water supply may
require a backfl ow prevention device. This is
to ensure that there is no feedback of chemi-
cals into the water supply. Use a water fi lter to
avoid potential damage from dirt in the water
supply.
■ Garden hose must be at least 5/8 inch
diameter.
■ Flow rate of water supply must not fall below
2.5 GPM (gallons per minute)
■ Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
■ The water supply temperature must not ex-
ceed 104°F/40°C.
■ Never use the pressure washer to draw in
water contaminated with solvents, e.g. paint
thinners, gasoline, oil, etc.
■ Always prevent debris from being drawn into
the unit by using a clean water source. Use
additional water fi lter.
■ Do not operate pressure washer without the
water turned on.