Showerhead INSTALLATION INSTRUCTIONS P24760 1226928-2-A 1 of 3 KALLISTA ©2014 Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Showerhead INSTALLATION INSTRUCTIONS THANK YOU FOR CHOOSING KALLISTA We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual before you install your KALLISTA product. If you encounter any installation or performance problems, please do not hesitate to contact us at the phone number listed at the bottom of the page. BEFORE YOU BEGIN CAUTION: Risk of scalding. KALLISTA low-flow showerheads are designed for use with compatible KALLISTA valves.
Showerhead INSTALLATION INSTRUCTIONS INSTALL THE SHOWERHEAD Apply thread sealant. 1226928-2-A 3 of 3 Thread the showerhead on and tighten. Run cold and hot water through the shower arm for several minutes to flush out dirt and debris. Install the showerhead as shown. Secure the showerhead to the shower arm using a clean wrench. Pivot the showerhead to verify smooth operation. Run water through the showerhead to check for leaks between the shower arm and showerhead inlet. Adjust as needed.
Shower Arm INSTALLATION INSTRUCTIONS P24762 1226929-2-C 1 of 4 KALLISTA ©2014 Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Shower Arm INSTALLATION INSTRUCTIONS THANK YOU FOR CHOOSING KALLISTA We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual before you install your KALLISTA product. If you encounter any installation or performance problems, please do not hesitate to contact us at the phone number listed at the bottom of the page. BEFORE YOU BEGIN Observe all local plumbing and building codes. Shut off the water supply.
Shower Arm INSTALLATION INSTRUCTIONS INSTALL THE SHOWER ARM Finished Wall Pipe Nipple Shower Arm Thread Sealant Adapter 1/2" (13 mm) Hex Wrench Apply plumbers putty. Shower Arm Install a male 1/2″ NPT pipe to extend 1/2″ (13 mm) beyond the finished wall. Apply sealant tape to the exposed threads of the pipe nipple. Apply a bead of plumbers putty or other sealant to the back of the shower arm according to the putty manufacturer’s instructions. Thread the shower arm to the pipe nipple.
Shower Arm INSTALLATION INSTRUCTIONS COMPLETE THE INSTALLATION Hex Wrench Shower Arm Adapter Adapter Thread Sealant Showerhead Adjustable Wrench Apply thread sealant to the shower arm adapter. Thread the adapter tightly into the showerhead while securing the ball joint with a wrench. Be careful not to scratch the finish with the wrench. Thread the showerhead tightly into the shower arm. Check for proper operation.
Thermometer WARNING: Risk of scalding. High water temperature can cause severe burns. Set the water temperature at or below 120°F (49°C) following the adjustment procedure in this document. WARNING: Risk of scalding. This valve will not protect against scalding if incoming water temperature changes significantly during operation. 1 Turn off the water supply to the 2 valve. If the test cap is installed, remove it now. Confirm the O-rings are undamaged and properly seated around each port and the base.
Install a deep rough-in kit if “A” is 10 IMPORTANT! To determine the less than 1-1/4" (32 mm). correct deep rough-in kit, go to the www.kallista.com page for this product and refer to the specification sheet. 11 Install the shower trim following the instructions provided with the trim. Finished Wall A FIVE-YEAR LIMITED WARRANTY All Kallista products carry Kallista's five-year limited warranty unless otherwise noted.