Operation Manual

10
Connections
• Picture distortion may occur when connecting the TV via
a VCR, or to a TV with a built-in VCR.
• You need to set “MONITOR TYPE” in the PICTURE
menu correctly according to the aspect ratio of your TV.
(See page 32.)
* Some TV’s SCART connectors emit audio signals. In such
a case, you can enjoy the TV sound through this system
by selecting TV SOUND as the source to play. (See page
13.)
NOTE
• No sound signal comes out from AV OUT (SCART)
connector.
• Select the appropriate video output mode according to your
TV. (See page 14.)
You can connect a USB mass storage class device such as a
USB flash memory device, hard disk drive, multimedia card
reader, digital camera, etc. to this system.
• After connecting a USB mass storage class device to this
system and selecting USB MEMORY as the source, the
file control display appears on the TV screen. (See page
25.)
NOTE
• When connecting a USB mass storage class device, refer also
to its manual.
• Connect one USB mass storage class device to the system at a
time. Do not use a USB hub.
• While playing back a file on a USB mass storage class device,
do not disconnect the device. It may cause a malfunction of
both the system and the device.
• Some USB mass storage class devices may not be recognized
or may not work properly.
• JVC bears no responsibility for any loss of data on the USB
mass storage class device while using this system.
• This system is compatible with the USB 2.0 Full Speed.
• You can play back the following types of files on a USB mass
storage class device (maximum data transfer rate: 2 Mbps):
–Music: MP3, WMA
–Picture: JPEG
– Movie: MPEG-4 (ASF), DivX (maximum frame rate of
30 fps for progressive)
• This system may not play back some files even though their
formats are listed above.
• You cannot play back a file larger than 2 GB.
• When playing a file which has a large transfer rate, frames or
sounds may be dropped during playback.
• This system cannot recognize a USB mass storage class
device whose rating exceeds 5 V/500 mA.
• You cannot connect a computer to the USB MEMORY
terminal of the system.
• Always set the volume to the minimum level when
connecting or disconnecting the other equipment.
• You cannot send any data to your USB mass storage class
device from this system.
• When connecting with a USB cable, use the USB 2.0 cable
whose length is less than 1 m.
Make sure that all other connections have been completed.
CAUTION
• Disconnect the power cord before cleaning or moving the
system.
• Do not pull on the power cord to unplug it. When
unplugging the cord, always grasp and pull the plug so as not
to damage the cord.
NOTE
• Preset settings, such as preset stations and surround mode
adjustments, may be erased after a few days in the following
cases:
– If you unplug the power cord of the center unit.
– If a power failure occurs.
Connecting a TV
Connecting a USB mass
storage class device
Center unit
TV
SCART cable (not supplied)
To SCART connector*
Center unit (on the front panel)
USB memory (not
supplied)
USB cable (not supplied)
Or
Connecting the power cord
Center unit
Power cord
Plug into an AC outlet.
Do not connect the power cord until all other connections have been made.
EN_TH-U1[B]-03body.fm Page 10 Wednesday, July 25, 2007 4:06 PM