Compact Component System Instructions

6
Introduction
You can operate your TV using the remote control
of this system.
Setting the manufacturer code
1 Slide the remote control
mode selector to TV.
2 Hold down F TV.
• Hold down F TV until you finish step 4.
3 Press ENTER and release.
4 Press number buttons (1-9, 0).
• Refer to “Using the number buttons”
(A page 15).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
When the manufacturer of your TV has two or
more codes, select the manufacturer codes in turn
and find the one that operates the TV and the
remote control properly.
NOTE
• A manufacturer code is subject to change without
notice. You may not be able to operate the TV
produced by the manufacturer.
5 Release F TV.
Using the remote control for the TV operation
Operate the remote control by pointing it at the TV.
*1 Make sure to slide the remote control mode
selector to TV in advance.
NOTE
• After replacing the batteries of the remote control,
set the manufacturer code again.
• When the remote control mode selector is slid to TV,
some buttons may not work.
Operating the TV using
the remote control
F TV
TV/VIDEO
TV
CHANNEL
TV
VOLUME
ENTER
Number
buttons
Remote control
mode selector
Manufacturer Code Manufacturer Code
JVC 01 Samsung 12
Hitachi 10 Sanyo 13
Magnavox 02 Sharp 06
Mitsubishi 03 Sony 07
Panasonic 04, 11 Toshiba 08
Philips 14 Zenith 09
RCA 05
Turns on/off the TV.
Changes the channels.
Adjusts the volume.
Selects the channels.
Switches the
previously selected
channel and the
current channel.
Switches the TV and video input.
/
/
~
*1
EXA10[A_Ux]-01.fm Page 6 Friday, September 2, 2005 2:39 PM