Audio/Video Control Receiver Instructions
59
IMPORTANT:
To operate JVC’s video components using this remote control:
• You need to connect JVC video components through the AV
COMPU LINK terminals (see page 54) in addition to the
connections using cables with RCA pin plugs (see pages 7 and 8).
• Some JVC VCRs can accept two types of the control signals —
remote codes “A” and “B.” Before using this remote control, make
sure that the remote control code of the VCR connected to the
VCR 1 jacks is set to code “A.”
– When another JVC VCR is connected to the CDR/VCR 2 jacks,
set its remote control code to code “B.” (This remote control
cannot emit the control signals of code “B.”)
• To operate the video components only using this remote control,
aim the remote control at the remote sensors on the target video
component(s) directly. (For the TV having AV COMPU LINK
terminal “RECEIVER/AMP,” aim the remote control directly at
the remote sensor on the receiver.)
• To operate the video component(s) using the RF signals emitted
from this remote control, the IR signal transmitter and the RF rod
antenna must be connected to this receiver.
– Place the IR signal transmitter so that it is aimed at the remote
sensor on the target video component(s).
– The RF signal-reachable distance may differ depending on the
operating conditions and circumstances.
– The IR signal transmitter can send signals at a distance of 10
feet (3 m).
VCR 1 (VCR connected to the
VCR 1 jacks)
You can always perform the following operations (with the remote
control mode selector set to “AUDIO/TV/VCR”):
VCR 1 POWER: Turns on or off the VCR 1.
After pressing VCR 1 or VCR 1 CONTROL (with the remote
control mode selector set to “AUDIO/TV/VCR”), you can perform
the following operations on the VCR 1:
1 – 9, 0: Selects the TV channels on VCR 1.
PLAY: Starts playing.
REW: Rewinds a tape.
FF: Fast winds a tape.
STOP: Stops operations.
PAUSE: Pauses playing. To release it, press PLAY.
¶ REC: Press this button with the PLAY button to start
recording. (Only for the main room operations)
Press this button with the PAUSE button to enter
recording pause.
CHANNEL +/–: Changes the TV channels on the VCR.
Note:
You can use either VCR 1 button or the VCR 1 CONTROL button to
activate the buttons listed above. If you press VCR 1, the playing
source also changes. On the other hand, if you press VCR 1
CONTROL, the playing source does not change.
DVD player
After pressing DVD (or DVD MULTI: only for the main room
operations) (with the remote control mode selector set to “AUDIO/
TV/VCR”), you can perform the following operations on a DVD
player:
PLAY: Starts playing.
4: Returns to the beginning of the current (or previous) track.
¢: Skips to the beginning of the next track.
STOP: Stops playing.
PAUSE: Stops playing temporarily. To release it, press PLAY.
After pressing DVD (or DVD
MULTI: only for the main room
operations), these buttons can be
used for the DVD menu operations.
Note:
For detailed menu operations, refer to the instructions supplied
with the discs or the DVD player.
TV
You can always perform the following operations only for the main
room operations (with the remote control mode selector set to
“AUDIO/TV/VCR”):
TV/CATV/DBS POWER: Turns on or off the TV.
TV VOL +/–: Adjusts the volume.
TV/VIDEO: Sets the input mode (either TV or VIDEO).
After pressing TV/DBS (with the remote control mode selector set
to “AUDIO/TV/VCR”), you can perform the following operations
on a TV:
CHANNEL +/–: Changes the channels.
1 – 9, 0, 100+: Selects the channels.
RETURN: Alternates between the previously selected channel
and the current channel.
CENTER
REAR TONE
REAR-L
REAR-R
23
456
8
MENUMENU
ENTERENTER
Check to see if the
remote control
mode selector is set
to the correct
position.
To operate the
audio system, TVs,
VCRs, and DVD
players, set it to
“AUDIO/TV/VCR.”
Check to see if the
multi-room
operation selector
is set to the
correct position.
To operate the
receiver for the
main room, set it
to “MAIN ROOM.”
To operate the
receiver for the
sub-room, set it
to “SUB ROOM.”
RM-SRX9000J REMOTE CONTROL
CONTROL
CHANNEL VOLUMETV VOL
TUNING
STOP PAUSE
FF/
/REW
VCR 1
TV/VIDEO
TAPE/MD
MUTING
REC
PLAY
DOWN UP
DVD DVD MUILTI CD TAPE/MD
TV/DBS VIDEO PHONO FM/AM
VCR 1
CDR/VCR 2
ANALOG/DIGITAL
SURROUND CNTR TONE
CENTER
SURROUND
REAR TONE
REAR-L
CD-DISC
MODE
ON/OFF
SEA MODE REAR-R
SOUND
TEST
SUBWOOFER
RETURN FM MODE
SET
MENU
AUDIO/
TV/VCR
EXIT
TEXT
DISPLAY
SLEEP
123
456
7
/P
89
10
0
+10
100+
CATV/DBS
MENUMENU
ENTERENTER
STANDBY ON
TV/CATV/DBS
VCR 1
POWER POWER
MAIN ROOM
SUB ROOM
SUB
ROOM
MAIN
ROOM
ON/OFF ON/OFF
AUDIO/
TV/VCR
CATV/DBS
SUB
ROOM
MAIN
ROOM
EN54_65.RX-9000V[J]/f 00.2.15, 3:51 PM59