Audio/Video Control Receiver Instructions

Page 45

English

Simplifying the Operations Using the Remote Control

You can program and store a series of operations in a specific order you want. After making a program, you

can perform these programed operations at a press of the SEQUENTIAL PROGRAM KEY.

Programing a series of operations

You can make 3 different programs, each containing up to 16 steps.

1 Open the outside panel of the remote control.

2 Press LEARN so that the SEND/LEARN indicator lights up (green).

3 Close the outside panel.

4 Press SEQUENTIAL PROGRAM KEY A, B, or C to which you want to assign a program you

are making from now.

The SEND/LEARN indicator starts flashing.

Note:

If the ERROR indicator lights up (red) while the SEND/LEARN indicator is flashing, you have already

assigned a program to that SEQUENTIAL PROGRAM KEY. To add steps to the program, continue to step

5. If you do not want to change it, press another SEQUENTIAL PROGRAM KEY after the SEND/LEARN

indicator stops flashing.

5 While the SEND/LEARN indicator is flashing, press the button you want to store as the first

step of the program.

Both the SEND/LEARN and ERROR indicators light up, and then only the ERROR indicator goes

off.

When the SEND/LEARN indicator goes off and starts flashing again, the first step is stored.

The ERROR indicator lights up while the SEND/LEARN indicator is flashing.

Note:

If the SEND/LEARN indicator stops flashing before you press the button, repeat from step 4 again.

Remote: Inside

Remote: Outside

CANCELLEARN

SEQUENTIAL PROGRAM KEY

ABC

SEND/LEARN ERROR

Lights

SEND/LEARN ERROR

Lights

SEND/LEARN ERROR

Flashes

Lights

SEND/LEARN ERROR

Flashes

RX-730RBK(EF)0054-001A.En.42-52 97.7.25, 7:06 PM45