Audio/Video Control Receiver Instructions

ManualsBrandsJVC ManualsStereo ReceiverRX-730R

Page 34

English

10. Press Control

% /

ﬁﬁ

ﬁ until “TEST” appears on the display, then press Control

@ /

# to stop the

test tone.

11. Press Control

% /

ﬁﬁ

ﬁ until “CNT TONE” (Center Tone) appears on the display.

12. Press Control

@ /

# to select the center tone you want.

The center tone adjustment affects the mid-frequency range, which the human voice is mostly made

up of.

Each time you press the button, the display changes to show the following:

To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much).

To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much).

When “FLAT” is selected, no adjustment is applied.

Note:

The center tone cannot be adjusted when sounds do not come out of the center speaker.

From the remote control:

Note:

If you want to use the remote control for adjusting the center mode and the center tone, use the menu function

(see page 40).

1. Press SURROUND MODE until “PROLOGIC” or “3CHLOGIC” whichever you want appears

on the display.

The PRO LOGIC or 3CH LOGIC indicator (as well as the SURROUND indicator) also lights up.

Each time you press the button, the surround modes change as follows (the indicator of the selected

surround mode also lights up on the display):

2. Open the outside panel and press SOUND CONTROL on the remote mode section.

The remote control is activated for adjusting the sound.

3. Press DELAY to adjust the delay time of the rear speaker output.

Each time you press the button, the delay time changes as follows:

Note:

When you have selected “3CHLOGIC,” you cannot adjust the delay time.

Front panel

SHARP1 SHARP2FLATSOFT2 SOFT1

PROLOGIC 3CHLOGIC

SURR OFF

HALL

(Surround Off)

DELAY 1

DELAY 2

DELAY 4

DELAY 3

SOUND

CONTROL

Remote: Outside

SURROUND

MODE

Remote: Inside

Continued to the next page

DELAY

RX-730RBK(EF)0054-001A.En.29-36 97.7.25, 6:37 PM34