CD Player User Manual

ManualsBrandsJVC ManualsMP3 PlayerRC-EZ35S

INSTRUCTIONS

CD PORTABLE SYSTEM

RC-EZ35S

PRESET

FOLDER

REPEAT

STANDBY/

RANDOM

TAPE

MUTING

REMOTE CONTROL UNIT

RM-SRCEZ35 J

CD/ /

DISPLAY

PROGRAM

VOL

CLOCK

TUNER

FIRST THINGS

This portable system operates on battery or AC power.

FM telescopic antenna

Battery compartment

PHONES jack

AC outlet

Supplied power cord

BEAT CUT

INSERTING BATTERIES

1 Open the battery compartment cover.

Pull the battery compartment cover toward you while pressing the sections marked by the arrows.

2 Insert eight R20 (SUM-1)/D (13D)-size batteries. (not supplied)

Be sure to insert the batteries with the (+) and (–) terminals positioned correctly.

3 Replace the battery compartment cover.

Inserting Batteries into the Remote Control Unit:

Match the polarity (+ and –) of the batteries. R03 (UM–4)/AAA (24F)×2 (not supplied)

Note: The battery power will be switched off when you plug the power cord into the

AC IN

ÓÓ

Ó jack on the unit.

CAUTION:

To avoid battery leakage or explosion, handle batteries properly.

• If you are not going to use your system for a month or more, remove the batteries from the battery

compartment.

• Dispose of batteries in the proper manner, according to federal, state, and local regulations.

• Do not mix with different battery types or with new and old ones, or do not attempt to charge a

battery not intended to be recharged.

• Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.

SUPPRLYING AC POWER

Plug the power cord into the AC IN Ó jack on the back of the unit, and into an AC power outlet.

Note: To switch off the system completely, unplug the power cord.

CAUTIONS:

1. ONLY USE JVC POWER CORD PROVIDED WITH THIS UNIT TO AVOID MALFUNCTION OR

DAMAGE TO THE UNIT. REMOVE BATTERIES WHEN USING THE POWER CORD.

2. BE SURE TO UNPLUG THE POWER CORD FROM THE OUTLET WHEN GOING OUT OR WHEN

THE UNIT IS NOT IN USE FOR AN EXTENDED PERIOD OF TIME.

USING HEADPHONES

Connect commercially available headphones to the PHONES jack on the rear of the main unit. While the

headphones are connected, the speakers do not produce any sound. Before connecting the headphones,

make sure to turn down the sound volume.

ANTENNAS

The AM antenna is built in, so adjusting the position of the unit may help AM reception. The FM telescopic

antenna on the back of the unit can be extended and rotated for better FM reception.

For Customer Use:

Enter below the Model No. and Serial No.

which are located either on the rear, bot-

tom or side of the cabinet. Retain this

information for future reference.

Model No.

Serial No.

Thank you for purchasing this JVC product.

Please read these instructions carefully before starting operation to be sure to

obtain optimum performance and a longer service life from the unit.

SAFETY PRECAUTIONS

DO NOT EXPOSE TO RAIN OR MOISTURE

NE PAS EXPOSER À LA PLUIE NI À L'HUMIDITÉ

ATTENTION:RISQUE DE CHOC ELECTRIQUE, NE PAS OUVRIR

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert

the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure

that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the

presence of important operating and maintenance (servicing) instructions in the literature

accompanying the

appliance.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modification not approved by JVC could void the user’s authority to operate this equipment.

For Canada:

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Caution –– STANDBY/ON switch!

Disconnect the mains plug to shut the power off completely. The STANDBY/ON switch in any

position does not disconnect the mains line. The power can be remote controlled.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1. Do not remove screws, covers or cabinet.

2. Do not expose this appliance to rain or moisture.

3. To disconnect power from the mains, pull out the mains plug.

When installing the product, ensure that the plug is easily accessible.

IMPORTANT FOR LASER PRODUCTS

1. CLASS 1 LASER PRODUCT

2. CAUTION: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to

beam.

3. CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all

servicing to qualified service personnel.

NAMES OF PARTS AND CONTROLS

Top and front sides:

Main unit

91 243 6785

1312 14 15 161110

1VOLUME UP/DOWN buttons

2STANDBY/ON button

3 HBS button

4Tape operation buttons

PAUSE 8 button

STOP/EJECT § button

FF 1 button

REW ¡ button

PLAY 2 button

REC ÷ button

5 Disc door

6 PRESET EQ button

7PROGRAM/CLOCK SET button

Names of buttons:

Remote control unit

PRESET

FOLDER

REPEAT

STANDBY/

RANDOM

TAP E

MUTING

REMOTE CONTROL UNIT

RM-SRCEZ35 J

CD/ /

DISPLAY

PROGRAM

VOL

CLOCK

TUNER

1STANDBY/ON button

2TAPE button

CD/3/8 button

TUNER button

3 4 button

7 button

¢ button

4 FOLDER 5/∞ buttons

GENERAL CONTROLS

STANDBY/ON - Press to turn on/off the unit.

The display window lights up when the unit is turned on. (Note, however, that the display window does not

light even when the unit is turned on if the unit is operated on batteries.)

SETTING THE CLOCK

Before operating the unit any further, first set the clock built in this unit.

The clock uses 12-hour indication. “AM 12:00” indicates midnight, and “PM 12:00” indicates noon.

1 Press STANDBY/ON to turn off the unit, if it is turned on.

The clock flashes on the display window.

2 Press and hold PROGRAM/CLOCK SET for more than 2 seconds.

The hour digits start flashing.

3 Press 4 or ¢ to adjust the hour, then press PROGRAM/CLOCK SET.

The minute digits start flashing.

4 Press 4 or ¢ to adjust the minutes, then press PROGRAM/CLOCK SET.

Notes:

• If there is a power failure, the clock loses the setting and is reset to “AM 12:00.” The clock indication will

keep flashing until you set the clock again.

•You can also set the clock when the unit is in STANDBY mode. In this case, follow the procedures from

step 2.

ADJUSTING THE SOUND

Press VOLUME UP/DOWN (or VOL 5 or ∞ on the remote control unit) to increase or decrease the volume

to desired level. The volume level can be adjusted in 41 steps from “MIN” to “MAX”.

•Turning off the sound temporarily

During playback, press MUTING on the remote control unit to turn the sound off. “MUTING” appears in

the display window. Press it again to restore the sound.

• Reinforcing the bass sound

Press HBS so that the HBS indicator appears in the display window. You can enjoy powerful bass sound

with the Hyper-Bass Sound effect.

• Selecting the sound mode

You can select one of the 5 preset sound modes.

Press PRESET EQ repeatedly until the indicator for the sound mode you want appears in the display

window.

ROCK : Powerful sound emphasizing treble and bass.

JAZZ : Accented lower frequencies for jazz-type music.

POP : More presence in the vocals and midrange.

CLASSIC: Enriched sound with fine treble and ample bass.

No indication : Equalizer effect is canceled.

USING THE RADIO

TUNING IN RADIO STATIONS

1 Press TUNER to enter the tuner mode.

2 Press TUNER to select the band, FM or AM.

3 Press and hold 4 or ¢ for more than 1 second.

The unit starts searching and stops when a station of sufficient signal strength is tuned in.

If you press 4 or ¢ briefly and repeatedly, the frequency changes step by step.

Changing the FM reception mode

When an FM stereo broadcast is hard to receive or noisy, press FM MODE so that the STEREO indicator

disappears from the display window.

To restore the stereo effect, press FM MODE again so that the STEREO indicator appears in the display

window.

PRESETTING STATIONS

You can preset 24 FM and 16 AM stations.

1 Press TUNER to select the band, FM or AM.

2 Press 4 or ¢ to tune in the station you want to preset.

3 Press PROGRAM/CLOCK SET.

“— —” flashes in the display window.

4 Press PRESET UP/REPEAT to select the preset number.

You can use the number buttons on the remote control unit to select the preset number directly.

Example: To select preset number 5, press 5. To select preset number 15, press 1, then 5.

To select preset number 20, press 2, then 0.

5 Press PROGRAM/CLOCK SET.

The tuned station in step 2 is stored in the preset number selected in step 4.

Storing a new station on a used number erases the previously stored one.

6 Repeat steps 2 to 5 to preset other stations, using different preset numbers.

Tuning in a preset station

1 Press TUNER to select the band, FM or AM.

2 Press PRESET UP/REPEAT repeatedly until the desired preset number appears.

You can use the number buttons on the remote control unit to select the preset number directly.

Example:

To select preset number 5, press 5.

To select preset number 15, press 1, then 5.

To select preset number 20, press 2, then 0.

Note

If you unplug the AC power cord or if a power failure occurs, the preset stations will be erased in a few

days. If this happens, preset the stations again.

USING THE TAPE

|Forward direction

PAUSE

STOP/EJECT

REW PLAY

REC

PAUSE 8 – Press to interrupt tape play or record mode. Press a second time to resume tape play or tape

record mode.

STOP/EJECT § – Press to stop the current tape activity, or to open the cassette compartment door

when no buttons are active.

FF 1 – In stop mode, press to advance the tape toward the end. (When the tape reaches the end, press

STOP/EJECT § to release the depressed button.)

REW ¡ – In stop mode, press to rewind the tape toward the beginning. (When the tape reaches the end,

press STOP/EJECT § to release the depressed button.)

PLAY 2 – Press to play cassettes.

REC ÷ – Press to record from the radio or CD player.

PLAYING A CASSETTE TAPE

1. Press TAPE to enter the tape mode.

2. Press STOP/EJECT § to open the cassette compartment door.

3. Load a cassete. Use only a type-I normal tape.

4. Close the door securely.

5. Press PLAY 2 to begin playing the tape. The cassette tape plays until it reaches the end of the side,

then it automatically stops.

Fast-winding a tape

Press REW ¡ or FF 1.

When the tape reaches the end, press STOP/EJECT § to release REW ¡ or FF 1.

8 PRESET UP/REPEAT button

9 FM MODE button

10 RANDOM button

DISPLAY button

FOLDER – button

FOLDER + button

11 Display window

12 Cassette deck

13 REMOTE SENSOR

14 4 button

6 button

7 button

¢ button

15 TAPE button

16 TUNER button

5 Number buttons

6 MUTING button

7 DISPLAY button

8 RANDOM/PRESET – button

REPEAT/PRESET + button

PROGRAM/CLOCK button

9 EQ button

10 VOL 5/∞ buttons

Preset number

R20 (SUM-1)/D (13D)-size batteries

ENGLISH

1105KMMBICMTS

601-EZ3500-010

LVT1527-001C [J/C]

Summary of content (2 pages)

PAGE 1
FIRST THINGS ENGLISH This portable system operates on battery or AC power. CD PORTABLE SYSTEM 1 BEAT CUT PHONES jack STANDBY/ ON TAPE MUTING CD/ / PRESET RANDOM Press VOLUME UP/DOWN (or VOL 5 or ∞ on the remote control unit) to increase or decrease the volume to desired level. The volume level can be adjusted in 41 steps from “MIN” to “MAX”.
PAGE 2
RECORDING ON CASSETTE TAPES Displaying the disc information* (ID3 TAG) (MP3 disc only) (SKIP/SEARCH) PUSH PROGRAM/CLOCK SET STANDBY/ON You can record from the radio or the CD player. • It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable program and in any literary, dramatic, musical, or artistic work embodied therein.