Compact Component System Instructions Manual

– 25 –
English
CD Direct Recording
Everything on the CD goes onto the tape according to the
order of the CD.
On the unit ONLY:
1 Put a recordable cassette into deck B.
2 Load CDs.
3 Press one of the disc number
buttons (DISC 1, DISC 2 and
DISC 3) to select the disc, then 7.
4 Press DISC REC START.
“DISC REC START” appears, and the
(recording) indicator lights up on the display.
Deck B starts recording and the CD player
starts playing. When the recording is done,
“DISC REC FINISHED” appears on the
display and deck B stop.
To stop recording, press REC START/STOP or 7.
So that a 4-second blank portion is created on the
recording tape.
• Before recording on a tape, wind the tape on past the leader tape
(about the first 3 or 4 seconds of each side).
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse Mode indicator
lights up like – .
• When using the Reverse Mode for CD Direct Recording,
start recording in the forward direction first. When the
tape reaches its end while recording a song in the forward
direction , the last song will be re-recorded at the
beginning of the reverse side .
If you start recording on the reverse side , recording will
stop when recording is done only on one side (reverse) of
the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up – .
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse Mode indicator
lights up – .
• When using Reverse Mode for recording, start recording in
the forward direction first. Otherwise, recording will
stop when recording is done only on one side (reverse) of
the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up – .
Dubbing Tapes
You can record from one tape to another.
On the unit ONLY:
1 Press either TAPE–A 2 3 or TAPE–B 2 3,
then 7.
2 Put the source cassette into deck A, and a
recordable cassette into deck B.
• Put the cassettes in both decks so that the tapes will run
in the forward direction.
3 Press DUBBING.
The (recording) indicator lights up on the
display and dubbing starts.
To stop dubbing, press 7 so that both decks (A and B) stop.
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse Mode indicator
lights up – .
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up – .
CA-MXSK_ENUE24-33.p65 14/10/03, 10:52 AM25