Projection Television User's Guide

5) Install the new lamp unit.

Holding the handle attached to the new lamp unit, slide and push the new lamp straight into the

television and back into the lamp housing area. Do not forget to re-tighten the two screws.

Note: If the lamp does not sit securely in the TV (flat in the lamp housing area), it won’t turn on.

Make sure the lamp sits securely and flat in the housing area.

6) Re-install the lamp cover.

Insert the lamp cover in the right concave and close the lamp cover. Because the lamp cover

has a role to help prevent the danger of an electrical shock, tighten the screw using your

fingers.

Note:

• After installing the new lamp unit, do not forget to reset the lamp timer. See page 65.

4) Remove the lamp unit.

Using a Philips head type screwdriver (cross-head type), loosen the two screws fastening the

lamp unit. When the screws have been loosened, remove the lamp by raising the handle and

gently sliding the unit straight towards you. Place it carefully in the recycling packaging.

Lamp Replacement

WARNING!

Remember it is very important that YOU DO NOT TOUCH THE LAMP SURFACE. Please

read the warnings on page 85 again.

Also, replace the lamp with part number TS-CL110U only! The television is designed

to work specifically with this lamp. Lamps other than TS-CL110U may cause

malfunctions and/or other damage to the television.

To purchase a replacement lamp kit, please call 1-800-252-5722.

NOTICE (for USA)

This product has a High Intensity Discharge (HID)

lamp that contains mercury. Disposal of these

materials may be regulated in your community due

to environmental considerations. For disposal or

recycling information, please contact your local

authorities or for USA, the Electronic Industries

Alliance: http://www.eiae.org

LCT2067 Eng "D".indd 88LCT2067 Eng "D".indd 88 5/21/07 9:36:17 AM5/21/07 9:36:17 AM