HD Camera Recorder Instructions Manual

70
MENU SCREENS
AUDIO/MIC Menu Screen
In VTR mode, the screen changes to the AUDIO menu screen.
* This is not displayed in VTR mode.
Item Function/Setting (bold characters indicate initial settings)
TEST TONE Sets whether to output a test audio signal (1kHz, –20dBFS or –12dBFS) during color bar output.
OFF : A test audio signal is not output.
ON : A test audio signal is output.
MIC WIND CUT* Selects whether to cut the lows (low frequency bands) from the audio input signal.
Use this when you want to reduce wind sounds from the microphone.
OFF : Low frequencies are not cut.
INPUT1 : Only cuts the low frequencies in the audio from the INPUT1 connector.
INPUT2 : Only cuts the low frequencies in the audio from the INPUT2 connector.
BOTH : Cuts the low frequencies in the audio from both the INPUT1 and INPUT2 terminals.
AUDIO REF.LEVEL Sets the reference audio level on the tape. (Both CH-1 and CH-2)
–20dB : Records with –20 dB as the reference audio level.
–12dB : Records with –12 dB as the reference audio level.
Set this if you are playing back the recorded tape on an ordinary DV device.
* Set this for both playback and recording.
* This is unrelated to the audio level via the IEEE1394 signal.
INPUT1 MIC REF.* Sets the reference audio input level for the INPUT1 connector.
–50dB : Sets the reference audio input level at –50 dB.
–60dB : Sets the reference audio input level at –60 dB.
INPUT2 MIC REF.* Sets the reference audio input level for the INPUT2 connector.
–50dB : Sets the reference audio input level at –50 dB.
–60dB : Sets the reference audio input level at –60 dB.
AUDIO MONITOR Selects whether stereo or mixed audio is output from the PHONES jack when the MONITOR SELECT switch is set
to BOTH.
STEREO : Stereo audio (CH-1 audio is output to L and CH-2 audio is output to R)
* Outputs only the CH-1 audio from the monitor speaker.
MIX : Mixed audio (CH-1 and CH-2 mixed audio is output to L and R)
AUDIO MODE* Selects the audio sampling frequency for recording. (Both CH-1 and CH-2)
(When HDV format is set, this is fixed at 48K and “[48K]” is displayed.)
32K : Digitally records with a 12-bit, 32 kHz sampling frequency.
48K : Digitally records with a 16-bit, 48 kHz sampling frequency.
* If the DV format is 12-bit, 32 kHz, up to 4 recording track channels are available.
Of those, this camcorder records on the CH-1 and CH-2 channels. This camcorder is not capable of dubbing.
SEARCH AUDIO [DV] Selects whether to output audio when searching a tape recorded in DV format. (This also includes slow playback.)
ON : Audio is output.
OFF : Audio is not output.
PB AUDIO CH [DV] Selects which channel audio to output when playing back a DV tape with the audio signal recorded in 4 channels.
(Can only be set in VTR mode)
CH1/2 : Outputs the CH-1 and CH-2 channel audio.
This camcorder records the audio in CH-1 and CH-2 while shooting.
MIX : Outputs all 4 channels of audio at the same time.
CH3/4 : Outputs the CH-3 and CH-4 channel audio.
MEMO
This camcorder does not have a function for dubbing to the CH-3 and CH-4 channels.
PAGE BACK When the cursor is in this position, press the SHUTTER dial to return to the TOP MENU screen.
e_hd100.book Page 70 Thursday, July 14, 2005 5:28 PM