Compact Component System Instructions

11
Connecting the subwoofer
When you connect this system with an amplifier-
built-in subwoofer (not supplied), you can enjoy a
more dynamic bass sound. Refer to the manual of
the subwoofer for details.
To produce sound from the subwoofer, press
S.WFR OUT on the remote control to display
“S. WOOFER ON” (Subwoofer on) in the display
window on the receiver. Each time you press
S.WFR OUT, the display toggles between
“S. WOOFER ON” and “S. WOOFER OFF”.
NOTE
• When “S. WOOFER ON” is selected, bass sound
from the left and right speakers will be automatically
turned down and the bass sound will be emitted
mainly from the subwoofer.
Connecting other speakers
To connect speakers other than the ones supplied,
follow the operations shown below.
1 Slide the remote control
mode selector to
RECEIVER.
2 Connect the speakers to the
SPEAKERS WOOFER LEFT and
RIGHT terminals on the
receiver.
3 Hold down BASS ADJUST for 2
or more seconds.
• “Single Amp” is displayed in the display
window on the receiver, and no audio signal
is sent to the SPEAKERS TWEETER LEFT
and RIGHT terminals.
Display on the receiver
NOTE
• The impedance of speakers connected to this
system must be within the range 6
C to 16 C .
• When connecting the supplied speakers to the
receiver, hold down BASS ADJUST on the remote
control for 2 or more seconds once again to select
“Bi-Amp” in the display window on the receiver.
Connecting other equipment
7
2 /3 (cursor)/
ENTER
SCAN MODE
S. WFR OUT
Remote control
mode selector
BASS
ADJUST
Audio cord (not supplied)
(If an audio cord comes with the amplifier-built-in
subwoofer, you can use the audio cord.)
A
mplifier-built-in subwoofer
(not supplied)
Receiver
(rear panel)
Do not turn on the power until you complete the connection.
Connections (continued)
EXA10[A_Ux].book Page 11 Tuesday, August 30, 2005 3:53 PM