Operation Manual

Loading Batteries into the Remote Control

If the remote control

has to be brought closer to the projector to operate, it means that the batteries are wearing out.

Replace the batteries with new ones (AAA).

Insert the batteries according to the t s marks. Be sure to insert the s end first.

If an error occurs while using the remote control, remove the batteries and wait for five minutes. Load the batteries

again and operate the remote control.

Effective Range of Remote Control Unit

When aiming the remote control toward the sensor on this

unit

(front

rear),

ensure that the distance to the sensor

is within 7 m.

If the remote control fails to work properly, move closer

to this unit.

30°

20°

Remote Control

This unit

Control through reflection off a screen, etc.

Ensure that the total of distance A (between this unit and

the screen) and distance B (between the remote control

and the screen) is within 7 m.

As the efficiency of signals reflected from the remote

control unit varies with the type of screen used, the

operable distance may decrease.

30°

20°

Screen

Remote Control

This unit

CAUTION

Do not put the remote control in a place with an exposure to direct sun light or high temperature.

It may deformed due to heat, or the internal components may be adversely affected resulting in fire hazard.

Remove the batteries from the remote control when storing the remote control.

Storing the remote control for a prolonged period without removing the batteries can cause battery leakage.

Getting Started