User's Manual

2
When using the optional stay / 若選用支撐架
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they
could damage the unit.
注意 ：把本機安裝在托座上時，務必使用 8 mm 長的螺絲釘。如使用過長的螺絲釘，會損壞本機。
Bracket*
2
托座 *
2
Pocket
空殼
Flat head screws (M5 × 8 mm)
*
2
平頭螺絲釘（M5 × 8 mm）*
2
Screw (option)
螺絲釘（選用的）
Stay (option)
支撐架（選用的）
Fire wall
防火板
Dashboard
儀表板
Install the unit at an angle of less than 30˚.
將本機安裝在少於 30˚ 的角度。
Removing the unit
Before removing the unit, release the rear section.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
按圖所示，將兩片板條型把手插入卡槽，然
後輕穩地從兩側向外拉兩片把手，本機隨
之拉出。
Do the required electrical connections.
進行所需的電路連接。
Bend the appropriate tabs to hold the
sleeve firmly in place.
弄彎機殼的突舌，把外套機殼牢固
在儀表板內。
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
When installing the unit without using the sleeve / 若不使用外套機殼安裝本機
In a Toyota car for example, first remove the car radio and install the unit in its place.
以豐田牌（TOYOTA）汽車為例：首先取出汽車收音機，然後將本機裝入其空出的位置。
*
1
When you stand the unit, be careful not to damage the fuse on the rear.
*
2
Not supplied for this unit.
安裝（裝設、固定在儀表板內）
下面的圖解表示了典型的安裝程序。如果您有問題，或需要有關配套元件的資料，請向 JVC
汽車音響分銷商或配套元件供應公司詢問。
• 如果您不能確定如何正確地安裝本機，應請合格的技術人員來安裝。
拆卸本機
在拆卸本機前，應將本機後部的固定和連接部分鬆開。
Flat head screws (M5 × 8 mm) *
2
平頭螺絲釘（M5 × 8 mm）*
2
Bracket *
2
托座*
2
*
1
您豎起本機時，小心不要損壞底部的保險絲。
*
2
不隨本機提供。
For KD-R306/KD-R305 /
對應 KD-R306/KD-R305
Install1_KD-R306[U]_CT_2.indd 2Install1_KD-R306[U]_CT_2.indd 2 08.8.20 4:46:19 PM08.8.20 4:46:19 PM