VCR Instruction Manual

E-38
RECORDING – Recording method –
Main unit
Remote controller
Mini
PROFESSIONAL
SET
MENIU
EJECT
REC PLAY
PAUSE
REW
STOP
FF
DVCAM NTSC
PA L
REC INH.
CH-1/3
CH-2/4
BR-DV3000
A.DUB
OPERATE
INPUT SEL.REMOTE SEL.MIC
SERIAL
WIRELESS
9PIN
LINE
DV
Y/C
3.
PAUSE
button
5. STOP button
2. 4.
PLAY
button
2.
REC
button
A.DUB
F. REV
INDEX– INDEX+
PLAY
STOP
REMOTE CONTROL UNIT
RM-G3000
REW FF
PAUSE
REC
F. ADV
2. 4.
PLAY
button
2.
REC button
5.
STOP
button
3.
PAUSE button
Memo
• If recording has been
paused for an extended
period of time, the unit
will automatically go into
the STOP mode to pro-
tect the tape. The time
period after the lapse of
which the unit will enter
the STOP mode can be
configured via the LONG
PAUSE TIME item of the
SYSTEM (1/2) menu.
• This unit cannot perform
editing functions.
1. Load the cassette.
• Before loading the cassette, please check that the rear slide of
the cassette is pushed to REC.
¥ The Main unit is powered on.
2. Start recording.
• Hold down the REC button and press the PLAY button.
3. Pause recording.
• Press the PAUSE button.
4. Resume recording.
• Press the PLAY button.
5. Stop recording.
• Press the STOP button.
When the INDEX WRITE item of the SYSTEM (1/2) menu is
set as ON, an index signal is recorded at the starting position
of recording.
In the PLAYBACK mode, the position where the index signal is
recorded can be detected. (Index search)
 During recording, please press the REC button to record
the index signal.
* Please allow at least an interval of 1 minute between recording of
index signals.
Recording of index signals after tape recording is not possible.
Recording index signals
Memo
If recording is executed
right after the RECORD-
ING PAUSE state, index
signals will not be re-
corded.
BR-DV3000_E_p03-49 06.8.24, 1:38 PM38