User's Manual

CHARGING THE BATTERY PACK

ATTENTION:

◆

Always switch OFF a transceiver equipped with a battery pack

before inserting the transceiver into the charger.

1 Plug the AC adapter cable into the jack located on the rear

of the charger.

2 Plug the AC adapter into an AC outlet.

3 Slide a battery pack or a transceiver equipped with a battery

pack into the charging slot of the charger.

• Make sure the metal contacts of the battery pack mate securely

with the charger terminals.

• The indicator lights red and charging begins.

Indicator

4 When charging is completed, the indicator lights green.

Remove the battery pack or the transceiver from the

charging slot of the charger.

• It takes approximately 3 hours to charge the battery pack.

• When the charger will not be used for a long time, unplug the AC

adapter from the AC outlet.

Note:

◆ When the indicator blinks red, the battery pack is either

defective or the battery pack contacts are not properly mated

with those of the charger.

◆ When the indicator ﬂ ashes green and orange, the battery pack

has not satisﬁ ed the charging start temperature. Remove the

battery pack from the charger and wait until it reaches a normal

temperature before charging it again.

◆ The ambient temperature should be between 41°F and 104°F

(5°C and 40°C) while charging is in progress. Charging outside

this range may not fully charge the battery.