Installation Guide

One Lithonia Way · Conyers, GA 30012 · Phone [phone]
Visit us at www.acuitybrands.com/juno-recessed
© 2022 Acuity Brands Lighting, Inc.
912-00386-001 REV C
DATE 10
/2022
PAGE | 2
INSTALLATION INSTRUCTIONS
Juno RetroBasics™ 4” & 5/6” LED Downlight Trim Kit - RB Series
LED IMPORTANT SAFETY INSTRUCTIONS
• To reduce the risk of death, personal injury, or property
damage from fire, electric shock, falling parts,
cuts/abrasions, and other hazards please read all
warnings and instructions included with and on the fixture
box and all fixture labels.
• Before installing, servicing, or performing routine
maintenance upon this equipment, follow these general
precautions.
• Installation and service of luminaires should be performed
by a qualified licensed electrician.
• Maintenance of the luminaires should be performed by
person(s) familiar with the luminaires’ construction and
operation and any hazards involved. Regular fixture
maintenance programs are recommended.
• It will occasionally be necessary to clean the outside of
the refractor/lens/trim. Frequency of cleaning will depend
on ambient dirt level and minimum light output which is
acceptable to user. Refractor/lens/trim should be washed
in a solution of warm water and any mild, non-abrasive
household detergent, rinsed with clean water and wiped
dry. Should optical assembly become dirty on the inside,
wipe refractor/lens and clean in above manner, replacing
damaged gaskets as necessary.
• DO NOT INSTALL DAMAGED PRODUCT! This luminaire
has been properly packed so that no parts should have
been damaged during transit. Inspect to confirm. Any part
damaged or broken during or after assembly should be
replaced.
• Recycle: For information on how to recycle LED electronic
products, please visit www.epa.gov.
• These instructions do not purport to cover all details or
variations in equipment nor to provide every possible
contingency to meet in connection with installation,
operation, or maintenance. Should further information be
desired, or should particular problems arise which are not
covered sufficiently for the purchaser’s or owner’s
purposes, this matter should be referred to Acuity Brands
Lighting, Inc.
• WARNING RISK OF ELECTRIC SHOCK
• Disconnect or turn off power before installation or servicing.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code (NEC) and any applicable
local code requirements.
• All wiring connections should be capped with UL approved recognized wire connectors.
• CAUTION RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or performing
maintenance.
• Avoid direct eye exposure to the light source while it is on.
• WARNING RISK OF BURN
• Allow lamp/fixture to cool before handling. Do not touch enclosure or light source.
• Do not exceed maximum wattage marked on luminaire label.
• Follow all manufacturer’s warnings, recommendations, and restrictions for: driver type, burning position, mounting
locations/methods, replacement and recycling.
• CAUTION RISK OF FIRE
• Keep combustible and other materials that can burn, away from lamp/lens.
• Do not operate in close proximity to persons, combustible materials or substances affected by heat or drying.
• CAUTION RISK OF PRODUCT DAMAGE
• Never connect components under load.
• Do not mount or support these fixtures in a manner
that can cut the outer jacket or damage wire
insulation.
• Never connect an LED product to an unapproved
dimmer pack. Contact ABL directly for any dimmers
not specifically recommended for the product.
• Unless individual product specifications deem
otherwise: Allow for some volume of airspace around
fixture. Avoid covering LED fixtures with insulation,
foam, or other material that will prevent convection or
conduction cooling.
• Unless individual product specifications deem
otherwise: Maximum ambient temperature is 90°C.