Installation Guide

INSTALLATION INSTRUCTIONS
For J6RLG3 and J6RLEG3 Retrofit Trim Series
600 Lumen, 900 Lumen and WarmDim™ (Patent pending)
Juno J6RLG3 and J6RLEG3 Retrofit LED Trim Compatibility
Incandescent Housing Compatibility
The Juno J6RLG3 and J6RLEG3
trims are designed to work with
most standard UL listed 6” recessed
incandescent housings. When
used with standard medium base
incandescent housings, the medium
base socket adaptor must be
used. Housing compatibility can be
determined by measuring the recessed
housing as follows (Fig. 1):
A) Height: The housing must be at least
5-1/4” high
B) Diameter: The housing inside
diameter must be between 6”
and 6-3/4”
© 2012 Juno Lighting LLC Rev 7/12 P3435 pg 1 of 2
1300 South Wolf Road • Des Plaines, IL 60018 • Phone [phone] • www.junolightinggroup.com
Diameter
Height
Figure 1
WARNING: For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
NOTE: Juno recessed products are designed to meet the latest NEC requirements and are classified in full
compliance with UL 1598C. Before attempting installation of any recessed lighting product, check your local
electrical building code. This code sets the wiring standards and installation requirements for your locality and
should be understood before starting work.
SAVE THESE INSTRUCTIONS
Product Information
Juno’s J6RLG3 (downlight) and J6RLEG3 (eyeball) LED trims may be used as retrofit trims for 6” incandescent
housings already installed in application or with dedicated quick connect housings by Juno with part numbers
IC23-LEDT24 and IC23R-LEDT24.
The J6RLG3 and J6RLEG3 Retrofit trims consist of the following: Retrofit trim with quick connect, medium base
socket adaptor with mating quick connect and installation instructions. Check for all contents prior to installation.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING - Risk of fire or electric shock. Do not alter, relocate, or remove wiring, lampholders, power supply,
or any other electrical component.
WARNING - Risk of fire or electric shock. Installation of this retrofit assembly requires a person familiar with the
construction and operation of the luminaire’s electrical system and the hazard involved. If not qualified, do not attempt
installation. Contact qualified electrician.
WARNING - Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features and
dimensions described in these instructions.
WARNING - To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF THE
COMBINATION SHALL BE DETERMINED BY CSA OR AUTHORITIES HAVING JURISDICTION.
Dimming
The Juno J6RLG3 and J6RLEG3 LED trims require 120VAC input and are dimmable with the use of most incandescent, magnetic or
electronic low voltage wall box dimmers*. Contact Juno Lighting Group Product Services or visit www.junolightinggroup.com for a
current list of compatible dimmers.
Trim assembly has integral LED Driver. Replace entire trim assembly in the event of driver failure. Trim assembly replacements
must be performed by a qualified electrician.
*Electronic low voltage dimmers require a neutral wire connection in the wall box.