BUILDING YOUR TRAMPOLINE 1. This is a 2 person build. 2. Time for build is approximately 2 hours. 3. Choose a good location: (wood chippings, sand or grass). (7.3m) from ground level, away from wires, trees and other possible hazards. (2.5m) around sides, away from walls, fences, structures, roads and other hard surfaces and play areas.
STEP 1 : ASSEMBLING THE FRAME A Top tube You will need the following parts to complete section 1: Top tube B 6 x Top Tubes with T-connector A - Part A 6 x Top Tubes with T-connector B - Part B Leg center 12 x Leg extensions - Part C 6 x Legs centers - Part D Leg extension A First we will complete one of the four sections of the trampoline frame. B Slot the narrow end of the top tube with T-connector A into T-connector B. Insert the leg extensions into the leg center.
Important: The frame is held together under tension so you will have to use some force to insert certain parts. Place your feet on the top tubes and grip the leg extension with both hands. Pull the extension until it can be slotted into the T-connection (1 Slot the end of leg extension into the T-connection (2 Push down on the end of the leg center to fully inset the leg extension into the T-connection. Repeat the last six steps until you have assembled the four sections of the trampolines frame.
STEP 2 : ASSEMBLING THE FRAME This step will require 2 people who must be wearing gloves. Slot two of the frame section together as shown in the diagram. Whilst one person holds the assembled sections upright, the other person can slot a third section onto the end of the assembled sections. You will now need to slot the frame together, this will take some force. The easiest method is if the two people face each other.
STEP 4 : FITTING THE FRAME PAD This step will require 2 people. Lay the frame pad - Part H out over the edge of the frame with the ties facing downwards. Align the openings in the frame pad with the T-connector B's on the frame. Tie the outer elastic straps on the underside of the frame pad around the top tubes of the frame. completed step 4. WARNING: The trampoline MUST NOT be used during construction.
STEP 5 : FITTING THE ENCLOSURE TUBES Top enclosure tube You will need the following parts to complete step 5: Bottom enclosure tube 6 x Top enclosure tubes - Part I 6 x Bottom enclosure tubes - Part J 6 x Hemisphere caps - Part N Self tapping screw and washer You will also need a cross-head screwdriver (not supplied). Cross-head screwdriver Slot the thin end of one of the bottom enclosure tubes into the open end of one of the top enclosure tubes.
Then place the Hemisphere cap Part N onto the top enclosure pole Part I. Slot the bottom enclosure tube into the tubes in the T-connector B tubes visible through the slots in the frame pad. Assemble the five remaining enclosure tubes using the five self tapping screws and the cross-head screwdriver. Slot the remaining enclosure tubes with hemisphere caps into the remaining T-connector B’s on the frame. completed step 5.
STEP 7 : ATTACHING THE BOTTOM OF THE NET You will need the following parts to complete step 7: 8 x Cords - Part M. Tie the non-plastic end of the cord around a V-Ring. Push the red plastic end through a hole in the bottom of the netting. Important: Keep the cord tight at all times. Slot red plastic end of the cord through the middle of the next V-Ring along. Now slot the red plastic end back through the net and down through the next V-Ring.
17 to 27 29