User's Manual

5
2
6
3
7
4
1
Quick Start Guide
8
11
9
12
10
MONITOR SETUP
1.
The MobiCam
®
Digital Wireless Monitor is designed to be powered by
either the built-in rechargeable batteries or the provided AC/DC
adaptors. We recommend charging the Monitor for at least 8
hours before operating the unit in battery mode. Reconnect
the monitor to the adaptor whenever possible to maintain
battery life.
2.
Make sure the LCD switch (5), located on the right hand
side of your monitor, is in the ON position.
3.
Make sure the channel selector on the back of your
monitor is set to channel A. Your monitor will auto-
matically link up to your camera. (If you wish to link
and use more than one camera, please refer to your
owners Instruction Manual.)
4.
Adjust the volume and brightness of the screen by using the
control buttons on the front of your monitor to the desired setting.
To tilt your LCD screen up from the monitor housing, gently
press down the right LCD frame corner in place before
pressing the LCD Release Button located under the monitor.
The screen will pop up slightly and ready for adjustment
to your desired angle. (As with any electronics screen
use gentle force to avoid damaging the display.)
7 - DC Power input
8 - Speaker
9 - Tilt Screen Release
10 - Antenna
11 - Channel Selector/Scan Mode
12 - Battery Door
1 - 2.4” Color LCD Screen
2 - Volume Control
3 - Brightness Control
4 - Power ON LED Indicator
5 - LCD and Power ON/OFF
6 - AV Output