Assembly Instruction

CAUTION:

Read instruction carefully and turn electricity off at main circuit breaker panel

before beginning installation.

Care and Cleaning

To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean

water, never a solvent)to wipe the surface of the fixture.

To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit

breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean

cloth(use clean water, never a solvent) to wipe the interior surface of the fixture

Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth

to dust or wipe carefully.

Estimated Assembly Time:30 minutes

Part List and Hardware List

Shade

PIECE DESCRIPTION PICTURE QUAN TITY PIECE DESCRIPTION PICTURE QUANTITY

Roped Hook

W ire Nut

Mounting Plate

Mounting Screw

Hanging Loop

Canopy

Canopy Nut

Chain

Closable link/ cap

Socket Assembly

Finial

Bulb

1 / 3

PAGE 1
Assembly Instruction CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation. Care and Cleaning To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never a solvent)to wipe the surface of the fixture. To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Installation Step 1 H Unpack all parts from cartons carefully. Extend the bottom nipple of the Socket Assembly(H) through the washer of the Shade(J). Fix the Socket Assembly(H) in place by turning the Finial(K) clockwise till tight. Hook the top Socket Assembly(H) and Shade(J) with Roped Hook(I) as diagram. Step 2 Screw the Chain(G) to the Hanging Loop(D) and the loop of the Socket Assembly(H) with Closable link/cap (G1) as diagram.
PAGE 3
Grounding Instructions: a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector. b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire around green grounding screw on mounting bracket. Tighten ground screw.