8 Point Connector Crimp Tool CMP-1226 MANUAL
FEATURES CMP-1226 Crimp Tool Alignment Hole Selector CMP-3 Turret Head (sold separately) Turret Release Lever The CMP-1226 8 Point Crimp Tool is used for crimping wires (12-26 AWG) and contacts for electrical connectors. The CMP1226 is compatible with the M22520/1-01 tool. The CMP-1226 requires a turret head (sold separately to perform the crimping operation. More info for the Turret Heads (CMP-3) can be found at www.jonard.com.
5. Select the corresponding wire size on the selector knob by aligning the selection number/wire size with the selection arrow on the left side. To rotate the selector knob, remove the spring lock, pull the knob upward, rotate to the position needed, and release. Make sure the handles of the crimper are not compressed and the turret is released before rotating the selector knob. 6.